Service Parts List

54-49-1600

SERVICE PARTS LIST

BULLETIN NO.

MILWAUKEE TOOL



www.milwaukeetool.com

13135 W. LISBON RD., BROOKFIELD, WI 53005

Drwg. 1

EXAMPLE:

Component Parts (Small #) Are Included

When Ordering The Assembly (Large #).

2 3

49-16-2601

MANUAL CRIMPER

Apr. 2015

REVISED BULLETIN

WIRING INSTRUCTION

DATE

CATALOG NO.

SPECIFY CATALOG NO. AND SERIAL NO. WHEN ORDERING PARTS

SERIAL

NUMBER

FIG. PART NO. DESCRIPTION OF PART NO. REQ.

1 14-46-0545 Pin Kit (2)

2 --------------- Pin (2)

3 --------------- Spring (2)

4 --------------- Nut (2)

Correct

Adjustment

required

Adjusting

Set Screw

Locking

Set Screw

Inspection and Adjustment

Check tools periodically for correct adjustment. As with any tool, a slight amount of wear

may occur over time. This wear may be corrected by readjusting the tool as follows:

1. Remove any die inserts from the tool and make sure the jaw tips are free of dirt, etc.

2. Open tool and close handles until jaw tips just touch. DO NOT CLOSE HANDLES

COMPLETELY!

3. Check that the index marks (red grooves) on the toggle link and frame line up.

4. If the marks line up, the tool is in proper adjustment.

5. If the marks do not line up, loosen the locking set screw using a 1/4" (6.4 mm) hex

key, and then turn the adjustment screw clockwise or counterclockwise until the

marks line up.

6. Tighten the locking set screw securely; the tool is now properly adjusted and ready

for use.