Replacement Parts

20" JOBSITE ORGANIZER
Dec. 2014
54-49-8030
REVISED BULLETIN
SERVICE PARTS LIST
BULLETIN NO.
DATE
SPECIFY CATALOG NO. AND SERIAL NO. WHEN ORDERING PARTS
MILWAUKEE TOOL

www.milwaukeetool.com
13135 W. LISBON RD., BROOKFIELD, WI 53005
Drwg. 1
CATALOG NO. 48-22-8030
STARTING
SERIAL
EXAMPLE:
Component Parts (Small #) Are Included
When Ordering The Assembly (Large #).
0
00
FIG. PART NO. DESCRIPTION OF PART NO. REQ.
1 48-22-8030 20" Jobsite Organizer (1)
2 31-01-0501 Removable Bin Kit (1 Big and 4 Small) (2)
3 43-44-0015 Rope Gasket Seal (1)
4 44-20-0705 Side Latch Assembly (Set of 2) (1)
5 44-20-0710 Front Latch Assembly (Set of 2) (1)
6 31-44-0712 Handle Kit (1)
Note:
When installing a new Gasket Seal (3) it is recommended to start in the middle of the channel on
the hinge side of the lid. Route the rope gasket along the channel with a neutral tension applied to
the gasket, avoid stretching or bunching up the gasket in the channel. With your fi nger, press the
gasket into the channel to seat it into position. The gasket is properly installed when the routing of
the material fi lls the channel and there is approximately 1/4” overlap of the two ends.
Complete the installation by butting the two ends of the
gasket material together and compressing the slight
excess of material together to create a tight joint.
If there is no overlap at the end of the installation,
remove the gasket and start over,
2 3 4
5 6
1
2
3 Rope
Gasket Seal
4
Removable Bin Kit
consists of one (1)
large bin and four (4)
small bins
5
Front Latch
(Set of 2)
Side Latch
(Set of 2)
Front
Handle
(with 2 pins)
6