Service Parts List S/N B30C

BULLETIN NO.
54-42-2402
SERVICE PARTS LIST
FIG. PART NO. DESCRIPTION OF PART NO. REQ.
1 05-88-1010 M2.5 x 6mm Pan Hd. Phillips Screw (1)
2 42-70-0580 Belt Clip (1)
3 --------------- Housing Halve- Left (1)
4 --------------- Battery Contact Plate (1)
5 --------------- Switch (1)
6 --------------- PCB Assembly (1)
7 31-01-0003 Light Pipe (1)
8 45-24-0096 Forward/Reverse Button (1)
29 --------------- Gearcase and Gearing (1)
42 06-65-0502 M2.5 x 37mm Steel Pin (2)
43 05-81-0205 M3 x 6mm Pan Hd. Phillips Screw (2)
44 45-88-1980 Spring Washer (2)
45 44-66-0155 Motor Mount Plate (1)
47 --------------- Motor with Pinion (1)
48 42-70-0058 Housing Clip (1)
49 --------------- Housing Halve- Right (1)
50 06-82-1080 M3 x 14mm Pan Hd. T-10 ST Screw (7)
53 10-20-0958 Warning Label (1)
55 12-20-2510 Service Nameplate (1)
60 14-29-0096 Gearcase Assembly (1)
61 23-30-0096 Motor Assembly (1)
62 23-66-1097 Variable Electronics Switch Assembly (1)
63 31-50-2401 Housing Assembly (1)
CATALOG NO. 2401-20
REVISED BULLETIN
54-42-2401
SPECIFY CATALOG NO. AND SERIAL NO. WHEN ORDERING PARTS
M12™ Sub-Compact 1/4" Hex Screwdriver
STARTING
SERIAL NO.
WIRING INSTRUCTION
B30C
DATE
Feb. 2014
MILWAUKEE ELECTRIC TOOL CORPORATION
13135 W. Lisbon Road, Brookfi eld, WI 53005
Drwg. 1
EXAMPLE:
Component Parts (Small #) Are Included
When Ordering The Assembly (Large #).
0
00
= Part number change from previous
service parts list.














3
8
4
5
6
43
(2x)
44
(2x)
42
(2x)
45
47
48
1
2
53
7
55 49 50(7x)
29
63
3 49
50
60
29 42
45
61
43 44
45 47
62
4 5
6
_
+
NOTE: The highlighted
small tab of the Motor
Mount Plate must be in-line
with the negative (-) terminal side of
the motor as illustrated to allow for the
correct placement of the motor and wiring
in the handle of the tool.
A dab of red paint
indicates positive
(+) terminal
FIG. NOTES:
43 Seating Torque is to be 6-12 kgf-cm (5-10.5 in-lbs).
45,60,61 Service replacement gearcase assembly (60) comes with a
motor mount plate (45) that must be removed and discarded
when servicing. A motor mount plate already exists on the
motor assembly (61).
53,55 A clean, dry surface is essential for proper performance for
any adhesive system. The area intended for application of
any adhesive label or nameplate must be prepared by
cleaning with isopropyl alcohol. The solvent is to be applied
with a clean, lint free applicator and the surface allowed to
dry before applying the label or nameplate.
SEE REVERSE SIDE