Miltel Wireless Data Link for Data Transfer Receiver/Repeater 2A FCC ID:MLLGL2RPT150 U s e r M a nua l Miltel Communications Ltd.
Table of Contents Chapter 1 Introduction.................................................................................................3 1.1 Purpose and Use............................................................................................3 1.2 System General Description ...........................................................................3 1.3 Theory of Operation .......................................................................................
Chapter 1 Introduction 1.1 Purpose and Use The Receiver/Repeater 2A (FCC ID:MLLGL2RPT150) is a data link transceiver that is used for data transfer in Miltel’s radio system. The system is used for utility consumption readings collection system as well as for other applications such as in agricultural systems. This device is installed on-site by a professional field technician, thus it includes technical terms.
The Transceiver device is marketed as two models (as a receiver or as a repeater) and under three different commercial trade names (Speed Repeater 2A / Receiver 2A, Galaxy Repeater 2A / Receiver 2A and IrriWise Repeater 2A / Receiver 2A). The Transceiver device (both receiver and repeater) can be hooked up to a PC or to a laptop computer for programming purposes during system setup. 1.3 Theory of Operation The Receiver/Repeater 2A is the intermediate link in the wireless data collection system.
Chapter 2 Technical Characteristics 2.1 Technical Specification 2.1.1 Electrical Max. output power 18 dBm Output frequency 150-170 MHz Carrier wave modulation 2 Level FSK Power supply 7 ÷ 15 VDC Receiver Sensitivity -117 dBm 2.1.2 Physical Operating temperature -30°C ÷+60°C Water Resistance Splash resistance (IP-64) Length 16.5 cm. Width 12 cm. Depth 7 cm. Weight (excl. mounting plate) 910 gr. Weight (incl. mounting plate) 1,160 gr.
2.2 FCC Label (see file: Sample Label) FCC ID: MLLGL2RPT150 Model : Receiver 2A S/N: YY-nnnnnn Miltel Communications Ltd. Made in Israel This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Chapter 3 Installation Instructions 3.1 General The Receiver/Repeater 2A should be installed by a professional technician. 3.2 Installation For on-site installation of the Receiver/Repeater 2A device, proceed as follows: 1) Loosen the four screws fastening the unit's panel and open the box end cover.
FCC Declaration of Conformity The products described in this manual, include: • IrriWise Receiver 2A (Transceiver) • IrriWise Repeater 2A (Transceiver) • Speed Receiver 2A (Transceiver) • Speed Repeater 2A (Transceiver) • Galaxy Receiver 2A (Transceiver) • Galaxy Repeater 2A (Transceiver) The above products comply with Part 15 of the FCC Rules.
NOTE: 1) The equipment user is required by the radio service rules to obtain a license before operating the equipment. Licensing of this equipment is the user’s responsibility, and licensability depends on the user’s classification and application, and on the selected frequency. The user is strongly urged to contact the appropriate telecommunications authority concerning proper licensing, and before choosing and ordering frequencies.