Instruction Sheet

Please read entire instruction sheet BEFORE installing Intelagate.
HOW TO INSTALL INTELAGATE
The Intelgate system is made up of 2 parts— the Charging
Unit that will plug into your truck’s 12V outlet (cigarette
lighter socket) and the Tailgate Sensor that simply sticks
onto your tailgate.
STEP 1: Unpackage all of the parts.
STEP 2: Plug the Charging Unit into the 12V outlet on your
truck’s dashboard. Ensure that power is running to the 12V
socket. The blue light on the Charging Unit should illuminate,
beep, then blink continuously.
(If there is no light, check the power to the socket. You may
need to start your truck or at least power the electronics in
the truck by turning the key in the ignition to a position that
turns the vehicle’s electrical system on.)
STEP 3: Insert the battery into the Tailgate Sensor unit.
IMPORTANT: Ensure the + side of the battery is facing away
from the circuit board. The plus sign should match the + sign
direction on the battery holder.
STEP 4: Once the blue light turns from blue to red or green,
you are almost finished. Screw the Tailgate Sensor onto the
Sensor base. Ensure the cap is fully sealed.
Once the Tailgate Sensor is adhered to your tailgate, it tells
the Charging Unit in the cab, if the tailgate is up or down.
The Tailgate Sensor should be placed high up on the
exterior side of your tailgate in either the left or right hand
side of the gate. Do not place the sensor on a wet or dirty
tailgate.
FCC statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this devise
must accept any interference received, including interference
that may cause undesired operation.
STEP 5: For the best bond, clean the exterior area of the
tailgate where the sensor will be adhered to. Simply peel the
adhesive backer off of the Tailgate Sensor and place onto the
surface of the tailgate. Press the sensor against the surface of
the tailgate for at least 20 seconds to ensure a good bond.
AFTER INSTALLATION
LED Status Lights on Charging Unit: ◆ Green LED:
Tailgate is up ◆ Red LED (Blinking): Tailgate is down ◆
Blue LED (Blinking): Tailgate Sensor is not
found
◆ Orange LED (Blinking): Low battery in Tailgate Sensor
TO REPLACE BATTERY
◆ Unscrew the Tailgate Sensor cap from
the Sensor base ◆ Replace the battery ◆
Check seal for any damage and make sure that
seal is seated properly ◆ Screw cap back on
TROUBLESHOOTING
The Tailgate Sensor may lose its connection with the
Charging Unit. If this happens, take the following steps:
◆ Ensure the Charging Unit is plugged into the
truck’s 12V outlet ◆ Remove the battery from the Tailgate
Sensor. Wait 30 seconds then put battery back
into the Tailgate Sensor module
◆ Wait for blue light to turn green or
blinking red
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment. NOTE: The manufacturer is not
responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such
modifications could not void the user’s authority to operate
the equipment.This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled environment and
meets the FCC radio frequency (RF) Exposure Guidelines