User Manual

ManualsBrandsMiller Edge ManualsElectronicsRF Link

AW12-RF/MRF-01 INSTALLATION INSTRUCTIONS

Preliminary

1- PARTS LIST

PART NUMBERS

-AW12-RF Single Channel

Transmitter/Air Wave™ Switch

Assembly

-MRF-01 Single Channel Receiver

-P/N=? Battery, CR2032

-(4) #6-20x3/4”, Screw, Self-Drilling

2- INSTALL TRANSMITTER/AIR

WAVE™SWITCH ASSY

-Open box, unpack battery and remove

lid from the AW12-RF.

-Install CR2032 battery as shown with

the “+” side up. Notice that the Red LED

blinks once upon insertion.

-Now position & attach, with provided

screws, your AW12-RF to your bottom

angle or end stile of your door. Replace

lid.

-Now, dependent upon your “kit”, make

the necessary airline connections.

Summary of content (4 pages)

PAGE 1
AW12-RF/MRF-01 INSTALLATION INSTRUCTIONS Preliminary 1- PARTS LIST PART NUMBERS -AW12-RF Single Channel Transmitter/Air Wave™ Switch Assembly -MRF-01 Single Channel Receiver -P/N=? Battery, CR2032 -(4) #6-20x3/4”, Screw, Self-Drilling 2- INSTALL TRANSMITTER/AIR WAVE™SWITCH ASSY -Open box, unpack battery and remove lid from the AW12-RF. -Install CR2032 battery as shown with the “+” side up. Notice that the Red LED blinks once upon insertion.
PAGE 2
3- INSTALL RECEIVER -Open box, remove lid from the MRF-01 receiver. -Position receiver on operator, so that its wiring will reach the operator terminal strip. Keep in mind that the Green antenna wire must be exposed to the AW12-RF Transmitter/Air Wave™ Switch. It cannot be behind any type of metal. -Connect the Red (+) & Black (-) to your 24VAC/DC source. The White wire connects to a low voltage COMMON terminal. The Yellow wire connects to your EDGE/SAFETY terminal.
PAGE 3
LED INDICATORS LED Color Green Yellow Function Description Power Status Red (per channel) Relay State Always On Usually On – Off if right out of the box, no transmitter associated. Wink Off once per TX message received. Blinks rapidly during Learn Mode. Off when Relay is Clear. On when Relay is in Fault. Blink very slowly for Low Battery. Blink slowly if no TX has been associated. On when this channel is in Learn Mode (Yellow blinking). Blinks rapidly when Learn Mode is complete.
PAGE 4
5- Specifications and Controls: Transmitter Unit Frequency: 915 MHz. FSK Modulation. Indicator Lights: Red LED: Tx Data Power Source: Batteries: CR2032 Coincell. 3.0VDC Lithium. Dimensions: Antenna: Integral PCB loop. Response Time: Nominal 70 msec; Safety Edge Input to Receiver Relay Contact Output.