User Manual

2-1. Open and unpack the battery and remove lid from the AW14-RF.
2-2. Install the CR2032 battery as shown with the “+” side up.
Notice that the RED LED blinks once upon insertion.
Replace the lid of the AW14-RF
2-3 Position and attach the AW14-RF to the bottom angle or end stile
of the door.
2-4 Depending on the configuration, make the necessary airline
connections.
P.O. Box 159 • West Grove, PA 19390 • 800-220-3343 • 610-869-4422 • Fax: [phone] • www.milleredge.com
6809 South Harl Ave., Suite A • Tempe, AZ 85283 • 800-887-3343 • 480-755-3565 • Fax: [phone]
Model # AW14-RF
I
N
S
T
A
LLA
TI
O
N
I
N
STR
U
C
TI
O
N
S
I
MPORTANT:
READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE BEGINNING INSTALLATION.
Parts List
1. AW14-RF Transmitter/Air Wave Switch Assembly
2. Battery, CR2032
1-
PART NUMBER
2- Install Transmitter / Air Switch Assembly
Tools Required:
1. 1/8” Phillips Head Screwdriver
2. Mounting Screws (not supplied)
Pending
3- Adjust The Switch Sensitivity
3-1 The AW14 is factory set and should rarely need to be adjusted.
If you determine that the switch sensitivity is not correct, to
make the switch more sensitive, turn the adjustment
screw clock-wise. This will move the screw closer to the
diaphragm inside the switch, thus less air movement is
required to activate the switch (LED will Blink).
Longer edges will require more sensitivity. Too sensitive
will cause unwanted activations caused from door vibration.
2-1 2-2
2-3
2-4
3-1
DRAFT
The AW14-RF switch offers installation time savings and improved visual aesthetics as there is no need
to hard wire a coil cord or retracting reel. The AW14-RF switch kit includes a MRF-01 receiver which is
wired to the motor controls.
Kits may be installed on a doors up to18 feet wide.