MWC-434m User Manual MWC-434m User Manual 60GHz RF/BB Module with USB3.0 interface Rev. 1.
MWC-434m User Manual Revision History Date Written by Rev. 21.02.15 Ken. Jung 1.0 MWC-434m User manual .1.0 Release 1.0 Update Module Integration Instruction 21.04.02 Ken. Jung Description Address: #423 , 105 YoungTong-Gu, SuWon-Si, GyeongGi-Do, 16229 Korea http://www.miliwave.co.kr/ Tel. 070-8825-0630 Fax. Email: sales@miliwave.co.kr Copyright © Miliwave Inc. 2020. All rights reserved.
MWC-434m User Manual 1.1 Overview Miliwave’s MWC-434m module operates in 60GHz unlicensed frequency band, IEEE802.11ad compliant, and is designed for Point to Multi-Pont (PTMP) or Point to Point (PTP) bridge wireless communication, primarily for Line-of Sight (LOS) operation.The MWC-434m module connects to a Linux based Host Communication Processor board via an available USB 3.0 Type-c port . All required drivers and firmware is pre-installed on the MWC-434M module as a self-contained device .
MWC-434m User Manual 1.3 MWC-434m Module Description The Miliwave's MWC-434m module in conjunction with the Host Communication Processor board can function as a PTP or PTMP bridge communication . Main chracteristics of the MWC-434m module include: - Adaptive Modulation and Link Adaptation: Up to 16QAM and MCS0-12 support - Phased Array Planar Antena: EIRP 28dBm, - Beam sweep range : Elevation 100°, Azimuth 100° - Advanced Security: AES-128 - Compact Form Factor: 45mm x 50mm x25mm - Connectivity: USB 3.
MWC-434m User Manual 8.0 Module Integration Instructions List of applicable FCC rules This module complies with part 15.255 of the FCC rules. Limitation of the module use case 15.255(a) Operation under the provisions of this section is not permitted for the following products: (1) Equipment used on satellites. (2) Field disturbance sensors, including vehicle radar systems, unless the field disturbance sensors are employed for fixed operation, or used as short-range devices for interactive motion sensing.
MWC-434m User Manual Information on test modes and additional testing requirements Testing of the host product with all the transmitters installed - referred to as the composite investigation test- is recommended, to verify that the host product meets all the applicable FCC rules. The host manufacturer can use the software to make the WiGig transmit continuously. Host User Manual The host manual shall include the following regulatory statement: This device complies with Part 15 of the FCC Rules.