SAFETY DATA SHEET MILES HYTEX-46 Section 1 – Identification 1.1Product Identifiers: Product Name: MILES HYTEX-46 1.2 Product Usage: Recommended Usage: Anti-wear Hydraulic Fluid Restricted Usage: Not intended for any other usage 1.3 Emergency Support: CHEMTREC United States +1(800) 424-9300 International +01 (703) 527-3887 1.4 Supplier Information: MILES LUBRICANTS LLC 66 Marine St. Farmingdale, NY 11735 United States Phone: 877-683-8086 Fax: 631-229-8000 Email :support@mileslubricants.com www.
.2 Label Elements: No Classified Hazards Precautionary: P201 Obtain Special Instructions Before Use. P202 Do Not Handle Until All Safety Precautions Are Understood. P281 Use Personal Protective Equipment As Required. Response: P308 If Exposed Or Concerned: Get Medical Advice/attention. Storage: P405 Store Locked Up. Disposal: P501 Dispose Of Container According To Regional Regulations. 2.3 Other Hazards Hazards not otherwise classified (HNOC): Avoid prolonged or repeated contact with motor oil.
Section 4 - First Aid Measures 4.1 First Aid Measures Eye Contact: Immediately flush eyes with plenty of water occasionally lifting the upper and lower eyelids. Check for and remove any contact lenses. Continue to rinse for at least 20 minutes. Get Medical Attention. Inhalation: Remove victim to fresh air and keep at rest in a position comfortable for breathing. If breathing is irregular or if respiratory arrest occurs, provide artificial respiration or oxygen by trained personnel.
Section 5 - Fire Fighting 5.1 Extinguishing Media Suitable Media & Unsuitable Media: CO2, Dry chemical, or Foam. Water can be used to cool and protect product. Do not use water jet as an extinguisher, it will spread the fire. 5.2 Specific hazards arising from this product: When heated, hazardous gases may be released including: sulfur dioxide. A solid stream of water will spread the burning material. Material creates a special hazard because it floats on water.
Spill Control Measures: Prevent the spread of any spill to minimize harm to human health and the environment if safe to do so. Wear complete and proper personal protective equipment following the recommendation of Section 8 at a minimum. Dike with suitable absorbent material like granulated clay. Dispose of according to Federal, State, Local, or Provincial regulations. Used fluid should be disposed of at a recycling center. Containment and Cleanup: Stop leak if without risk.
Section 8 - Exposure Control 8.1 United States Exposure Limits CAS 64742-55-8 64742-54-7 Chemical Name Distillates, petroleum, hydro treated light paraffinic Distillates, petroleum, hydro treated heavy paraffinic Exposure Limits 5mg/m3 Source NLM_CI 5mg/m3 IUCLID 8.2 Exposure Controls Engineering Controls: Material should be handled in enclosed vessels and equipment, in which case general room ventilation should be sufficient.
Section 9 - Physical & Chemical Properties 9.
Hazardous decomposition products: Carbon monoxide, Smoke, Carbon monoxide, sulfur oxides, aldehydes, and other petroleum decomposition products in the case of incomplete combustion. Oxides of nitrogen, phosphorus, calcium, copper, magnesium, sodium, and hydrogen sulfide may also be present. Section 11 - Toxicological Information 11.1 Toxicological Effects Ingestion Toxicity : No hazard in normal industrial use.
Section 12 - Ecological Information 12.1 Aquatic Toxicity Acute Aquatic ecotoxicity : Non-hazardous under Aquatic Acute Environment category. Chronic Aquatic ecotoxicity : Non-hazardous under Aquatic Chronic Environment category. Persistence and degradability : Biodegrades slowly. Bioaccumulative potential : Bioconcentration may occur. Mobility in soil : This material is expected to have essentially no mobility in soil. Results of PBT and vPvB assessment : Not determined.
Section 14 - Transportation Information 14.1 U.S. Department of Transportation (DOT) 14.2. Shipping Description: If shipped by land in a packaging having a capacity of 3,500 gallons or more, the provisions of 49 CFR, Part 130 apply. (Contains oil) International Maritime Dangerous Goods (IMDG) 14.2. DOT Compliance Note: U.S. DOT compliance requirements may apply. See 49 CFR 171.22, 23 & 25.
New Jersey Right to Know (NJ RTK): This material does not contain reportable chemicals. Massachusetts Right to Know (MA RTK): This material contains the following listed chemicals 64742-55-8 Pennsylvania Right to Know (PA RTK): This material does not contain reportable chemicals. Rhode Island Right to Know (RI RTK): This material does not contain reportable chemicals.