User's Manual

Seewww.routerboard.com formore information. Contactsupport@mikrotik.com forsupportquestions. 21/08/13

RouterBOARD QRTG2SHPnD

Quick Setup Guide and Warranty Information

The RouterBOARD QRT comes as acomplete kit. Itincludes abuilt

in802.11b/g/n dual chain wireless device, and adual polarization

17dBi antenna. Ithas one Gigabit Ethernetconnector which

supports MDIXauto detection.

First use

1. Connect anEthernet cable tothe port behind

the small plastic door

2. The QRT accepts 24V PassivePoEfrom aPoEinjector

3. The default IPaddress from LAN is 192.168.88.1for

configuration from a web browser

4. Username is admin and thereis no password

Powering

The device accepts powering from the Ethernetport(Passive PoE) 830V DC. Package contains a24V

adapter. Maximum power consumption of the device is 21W @24V. s

Bootingprocess

Initial connection has to be done viathe Ethernetcable. Open 192.168.88.1inyourwebbrowser.

Username is admin and there is no password. In case IP connection is notavailable, Winbox can be used

to connectto the MAC address of the device. More information here:

http://wiki.mikrotik.com/wiki/First_time_startup

In case you wish to bootthe device from network, for example to use MikroTik Netinstall, hold the

RESET button of the device when starting ituntil

the LED lightturns off, and Metal will startto look

for Netinstall servers.

Mounting

The QRT box contains several parts thatneed to be

assembled. Please follow this process:

Start by attaching thetwo polebrackets (A) to the

swivel adjuster (B), by using thefour provided screws

(use a PH1 screwdriver).

PAGE 1
RouterBOARD QRTG-‐2SHPnD Quick Setup Guide and Warranty Information The RouterBOARD QRT comes as a complete kit. It includes a built in 802.11b/g/n dual chain wireless device, and a dual polarization 17dBi antenna. It has one Gigabit Ethernet connector which supports MDI-‐X auto detection. First use 1. 2. 3. 4.
PAGE 2
Next, put the two U-‐bolts (C) around the mast or pole, and guide them through the holes on the swivel adjuster (D). Then, tighten the U-‐bolts, each with one regular washer, one spring washer, and one nut, as shown in the image to the right. All nuts need to be tightened using a size 10 (3/8 in) wrench. E Finally, attach the swivel adjuster to the mounting bracket. Use the long bolt in the position (F).
PAGE 3
Buttons and Jumpers � � RouterOS reset jumper hole (access through the plastic door) – resets RouterOS software to defaults. Must short circuit the metallic sides of the hole (with a screwdriver, for example) and boot the device. Hold screwdriver in place until RouterOS configuration is cleared.
PAGE 4
Federal Communication Commission Interference Statement (FCC ID: TV7QRTG2SHPND) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.