Manualshelf

Installation Instructions

ManualsBrandsMikrotikls ManualsElectronicsLicense Exempt Digital Transmission System Intentional Radiator
12345
Table Of Contents
MQS
The MQS – Mobile Quick Setup is a tiny wireless device. It is able to work in AP and in CPE modes and is
made to simplify MikroTik device configuration in the field.
Quickstart
• Power the device with USB, for example, from your laptop or a power bank.
• From your laptop or smartphone, connect to the MQS wireless network which starts with “RBMQS”.
• The MQS by default has DHCP server enabled on the wireless interface.
• The MQS management interface has an IP address 192.168.88.3. In order to avoid conflicts with other
MikroTik devices.
• Open http://192.168.88.3 in your web browser to start configuration, there is no password and user
name: Admin.
• We recommend clicking the “Check for updates” button and updating your system software to the latest
version to ensure the best performance and stability.
• Choose your country, to apply country regulation settings and set up your password in the screen that
loads.
LED indicators
1. The LED displays active POE.
2. Displays an active connection of the Ethernet
port.
3. Displays the access point mode.
4. Displays the station mode.
5. User LED indicates that the device is
currently in factory firmware, after the update
it will no longer be active, to bring the device
in factory firmware, hold reset button when
booting and LED will light up again.
6. Power LED indicates that the unit is receiving
power.
Mounting
If desired, the device can be mounted to with a zip tie through the opening on it’s back, or with provided strap or
with wall mounting bracket. The IP rating scale for this device is IPX0. To comply with health regulations, install
and use this device at least 20cm away from your body.
Powering
• MicroUSB port accepts 5 V powering.
• Ethernet port accepts passive Power over Ethernet 12-28 V DC (compensate for the loss on cable, so
more than 12 V recommended).
The power consumption under maximum load can reach up to 8 W.
Connecting to a POE Adapter:
1. Connect the Ethernet cable from the device to the POE+DATA port of the POE adapter.
2. Connect an Ethernet cable from your local network (LAN) to the POE adapter.
3. Connect the power cord to the adapter, and then plug the power cord into a power outlet.
See mikrotik.com/products for the latest version of this document. Document #51158 Modified on:22.AUG.2019

Summary of content (5 pages)