Installation Instructions

RB4011iGS+5HacQ2HnD-IN
The device is already configured with basic settings, you can simply plug in your ISP cable and start using the
Internet. We recommend you to set up a password to secure your device.
Setup
• Choose your powering solution, please see Powering section for possibilities.
• Connect your Internet cable to port 1, and local network devices to other ports.
• Set your computer IP configuration to automatic (DHCP).
• Wireless access point mode is enabled by default.
• Connect your direct input power jack if not using POE, to start up the device.
• The device will boot up and after short beep Wireless network will be available for connecting.
• Open network connections on your PC, mobile phone or other device and search for MikroTik wireless
network and connect to it.
• Once connected to the wireless network, open http://192.168.88.1 in your web browser to start
configuration, since there is no password by default, you will be logged in automatically.
• We recommend clicking the “Check for updates” button and updating your RouterOS software to the latest
version to ensure the best performance and stability.
• Choose your country, to apply country regulation settings and set up your password in the screen that
loads.
Powering
The power consumption under maximum load can reach 44 W. The device accepts powering from the power jack
or from the first Ethernet port:
• Direct-input power jack (5.5 mm outside and 2 mm inside, female, pin positive plug) accepts 12-57 V DC.
• First Ethernet port accepts Power over Ethernet 18-57 V DC.
Connecting to a POE Adapter:
1. Connect the Ethernet cable from the device to the POE port of the POE adapter.
2. Connect an Ethernet cable from your LAN to the LAN port of the POE adapter, please mind arrows for data
and power flow.
3. Connect the power cord to the adapter, and then plug the power cord into a power outlet.
See mikrotik.com/products for the latest version of this document. Document #50324 Modified on: 28.JUN.2019