Installation Plan Tumble dryer PT 8507 D (Steam Heated) en - US 05.15 M.-Nr.
U.S.A. Miele, Inc. National Headquarters 9 Independence Way Princeton, NJ 08540 Phone: 800-991-9380 609-419-4241 Fax: www.mieleusa.com Technical Service & Support Nationwide Phone: 800-991-9380 Fax: 800-220-1348 proservice@mieleusa.com It is essential to read the operating and installation instructions before installing, commissioning or using the machine. This avoids the risk of accidents or damage. All rights reserved.
47 1/2 >3/4 >3/4 64 5/8 24 3/4 30 1/8 64 5/8 20 1/2 47 1/4 28 1 1/2 63 PT 8507 D - measurements in inches 3
7 1/2 47 1/4 < 40 1/8 36 63 PT 8507 D - measurements in inches 6 3/8 6 1/4 5 7/8 2 4
12 3/4 34 1/2 66 7/8 12 4 7/8 17 5/8 7 7 7/8 66 7/8 27 3/4 2 1/8 PT 8507 D - measurements in inches 4 7/8 1/2 17 5/8 27 3/4 2 5/8 5
42 7/8 2 1/8 36 36 1/4 63 21 1/2 26 3/4 3/4 64 5/8 2 1/8 ~2 ~2 47 1/4 3/8 PT 8507 D - measurements in inches 6
3/4 64 5/8 42 7/8 >2 1/8 36 1/4 > 47 1/4 63 21 1/2 26 3/4 >2 >2 1/8 > 47 1/4 ~2 >2 1 7/8 3/8 PT 8507 D - measurements in inches 7
PT 8507 D - measurements in millimeters 8
< PT 8507 D - measurements in millimeters 9
PT 8507 D - measurements in millimeters 10
PT 8507 D - measurements in millimeters 11
PT 8507 D - measurements in millimeters 12
Technical datasheet Tumble dryer: Heating: PT 8507 Steam Legend: en - US Abbreviations in bold type: Connection required Abbreviations in circle with dashes: Connection optional or required depending on model version Optional extras: BS Concrete base Quality and density of concrete must comply with load. Concrete base must be firmly secured to floor! Recommended height Minimum height Width min. Depth min.
Electrical connection must comply with national regulations. Connection using multi-pole lockable wall socket in compliance with IEC/EN 60309 and IEC/EN 60947 is recommended in order to simplify electrical tests. If machines are hard-wired, a multi-pole mains switch must be provided on site. Switches with a contact gap of more than 3 mm can be used. These include switches, fuses and contactors (IEC/EN 60947). A wall socket or mains isolator must be easily accessible after installation.
Fittings (supplied) Without base 2 × clamps 2 × screws DIN 571 (Ø × length) 2 × rawl plugs (Ø × length) Machine must be bolted to the floor! Fixing materials for a floating screed floor are to be provided on site.
