install guide
Before using for the first time
21
Settings for compartment
The UltraPhase2 values are pre-set in
the standard settings.
After the cartridge has been pushed in,
the display message switches to:
Agent for
OK
Confirm with the OK sensor button.
Miele UltraPhase 2
OK
Confirm with the OK sensor button.
The dispensing quantity for
UltraPhase2 for (hardness level I)
is pre-set.
Per load
OK
ml
36
Confirm the pre-set value with the OK
sensor button or correct the value
with the sensor buttons and
confirm this with the OK sensor
button.
UltraPhase2
Hardness level I 36ml
Hardness level II 45ml
Hardness level III 54ml
The following will appear in the display:
Insert
Remove the stopper from the
detergent cartridge.
Push the UltraPhase2 detergent
cartridge into compartment until
it locks into position.
When the cartridge is pushed in, the
display message switches to:
"TwinDos" set. Can be changed in
"Settings".
Confirm with the OK sensor button.
Close the TwinDos flap.