Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the appliance
- Caring for the environment
- Before using for the first time
- Settings
- Opening the settings menu
- Changing settings
- Closing the settings menu
- Language
- Time of day
- Water hardness
- AutoDos (AutoDos)
- Rinse Aid
- Miele@home
- Remote control
- RemoteUpdate
- SmartStart
- EcoStart
- Display brightness
- Volume
- Refill reminders
- AutoOpen
- Extra Clean
- Extra Dry
- 2nd interim rinse
- Knock2open
- BrilliantLight
- Hygiene cycle
- Software version
- Showroom program
- Factory default
- Copyrights and licenses for the communication module
- Caring for the environment
- Loading the dishwasher
- Detergents
- Operation
- Options
- Program overview
- Program options
- Cleaning and care
- Frequently Asked Questions
- Customer Service
- Optional accessories
- Installation
- Sound emission testing
Frequently Asked Questions
98
Water intake fault
Problem Possible cause and solution
The in-operation indica-
tor light is flashing
quickly.
The alarm tone is
sounding.
One of the following
messages appears in
the display:
Open water supply The water supply is turned off.
Open the shut-off valve all the way.
Intake Before remedying the fault:
Turn off the dishwasher.
Water-intake fault.
Open the shut-off valve all the way and start the
program again.
Clean the water-intake filter (see “Cleaning the wa-
ter-intake filter” under “Cleaning and care”).
The water-connection pressure is lower than
7.25psi (50kPa).
Seek professional advice.
The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see “Water drainage” under “Installa-
tion”).
Fault F18 A technical fault has occurred.
Turn off the dishwasher.
Close the shut-off valve.
Contact Miele Customer Service.
The following fault mes-
sage appears during the
EnergySaver program:
Intake temperture low
The intake water has not reached the required tem-
perature of 115°F (45°C) (see “Water intake” under
“Installation”).
Start the program again.
If the fault message appears again, select a differ-
ent program.