Quick Start Guide for dishwashers These short instructions are not a substitute for the operating instructions supplied with the machine. It is essential to familiarise yourself with the dishwasher before using it for the first time. Take note of the Warning and Safety instructions, as well as the full descriptions on how to use your appliance. en-AU, NZ M.-Nr.
Guide to the appliance Control panel a Programme selection ECO 50 °C Auto 45 °C 65 °C 75 °C g Express sensor For reducing the programme duration. = ECO 50 °C = Auto 45–65 °C h OK sensor = Gentle 45 °C For selecting menu options and = QuickPowerWash 65 °C values displayed. For confirming messages. = Intensive 75 °C = Further programmes/ i sensors Settings For programme selection. For changing the values displayed. b Display For scrolling to other menu pages.
Brief instructions Filling the salt reservoir Remove the lower basket from the wash cabinet and unscrew the salt reservoir cap. Damage to the water softener from detergents. Dishwasher detergent will damage the water softener. Do not fill the salt reservoir with powder or liquid detergent. a AutoDos (automatic dispensing) b Detergent compartment c Rinse aid reservoir d Salt reservoir e Filter combination Risk of corrosion due to saline solution.
Adding rinse aid Automatic detergent dispensing Lift the yellow catch on the lid of the rinse aid container . Before you can use AutoDos, you must insert a PowerDisk containing powder detergent into the PowerDisk compartment. Only fill with rinse aid until the fill level indicator (see arrow) turns dark when the door is open horizontally. Close the lid making sure it clicks into place. Wipe up any spilled rinse aid. This prevents over-foaming occurring during the next programme.
Put the holder back into place so that the arrows point towards each other and the holder lies flat. When doing this, only hold the PowerDisk holder by the yellow tab in the middle. Do not hold it by the side tab. Manual detergent dispensing Insert the new PowerDisk and press it evenly downwards until it sits flush. Unless directed otherwise, use one detergent tab or add 20 to 30 ml of detergent to the detergent compartment, depending on the degree of soiling of the crockery.
Switching on Programme end - Switching off Close the door. The programme has finished when the message Finished appears in the display and the door has opened slightly (if applicable). Turn on the tap if it is turned off. Press the button. Selecting a programme Touch the sensor for the required programme. Further programmes can be selected under . Selecting programme options (if required) You can select and deselect programme options via the relevant sensors and the display.
Cleaning and care Cleaning the spray arms Particles of food can get stuck in the spray arm jets and bearings. The spray arms should therefore be inspected regularly (approx. every 2–4 months). Do not run a wash programme without the lower spray arm or without the filters fitted. Switch the dishwasher off. Take out the cutlery tray (if your dishwasher is fitted with one). Push the upper spray arm upwards to engage the inner ratchet.
Checking the filters in the wash cabinet Do not run a wash programme without the filters or without the lower spray arm fitted. The message Check filters will appear in the display after every 50 programme sequences. Monitor the condition of the filter combination regularly and clean it if necessary. Confirm the message with OK. Cleaning the filters Switch the dishwasher off. Remove the lower spray arm.
Programme chart Crockery Food deposits Temperature-sensitive dishes, glasses and plastics Lightly dried-on food deposits Programme with glass care All fresh to dried-on food deposits Variable, sensor-controlled programme Lightly dried-on food deposits Short programme taking less than an hour Standard dried-on normal food deposits Water and energy saving programme Pots, pans, everyday porcelain and cutlery Stubborn dried-on, burnt-on food deposits containing starch or protein1 Maximum cleaning p
Programme2 Consumption estimate3 Energy consumption Gentle 45 °C Water consumption Programme duration Energy consumption Auto 45–65 °C Water consumption Programme duration Energy consumption QuickPowerWash 65 °C Water consumption Programme duration Energy consumption ECO 50 °C Water consumption Programme duration Energy consumption Intensive 75 °C QuickPowerWash 65 °C + Express Water consumption Programme duration Programme duration 13 minutes, no heating up, solely for flushing out
