Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Saving energy
- Guide to the appliance
- Switching on and off
- The correct temperature
- Using SuperFrost
- Temperature and door alarm
- Selecting additional settings
- Freezing and storing food
- Adjusting the interior fittings
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Information for dealers
- Installation
- Installation
- Installation dimensions
- Limiting the opening angle of the appliance door
- Changing the door hinges
- Building in the appliance
- Preparing the appliance
- With 5/8" (16 mm) thick cabinet walls only:
- Building in the appliance
- Securing the appliance in the niche
- Only for an appliance with a niche height greater than 55" (140 cm)
- Installing the cabinet door
- Adjusting the position of the door
- X: side adjustments
- Y: height adjustment
- Z: depth adjustment
- Water connection
- Electrical connection
Installation
*INSTALLATION*
79
Only for an appliance with a niche
height greater than 55" (140cm)
To give the appliance additional security
in the niche, push the rods supplied be-
tween the appliance and the cabinet
base:
First secure the handle to one of
the stabilizing rods.
Use the handle to push the stabilizing
rod into the guide as far as it will
go. Remove the handle and fit it to
the other stabilizing rod supplied and
push this into its guide as far as it will
go.
Tip: Keep the handle somewhere safe
in case you ever need to fit the appli-
ance into a new housing unit.
Close the appliance doors.
Installing the cabinet door
If installed in a run of units, make sure
that the top edge of the cabinet door
is at the same height as neighboring
unit doors.
The cabinet door must be installed
level, and not under tension.
The next section gives instructions on
how to install a cabinet door that is at
least 5/8" - 3/4" (16 - 19mm) thick.
The distance between the appliance
door and the mounting frame is set to
5/16" (8mm) at the factory. Check
this distance and adjust it if neces-
sary.
Push the installation aids to the
height of the cabinet door. The lower
contact edge X of the installation aids
must be at the same height as the
upper edge of the cabinet door to be
installed (symbol).