Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Saving energy
- Guide to the appliance
- Switching on and off
- The correct temperature
- Using SuperFrost
- Temperature and door alarm
- Selecting additional settings
- Freezing and storing food
- Adjusting the interior fittings
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Information for dealers
- Installation
- Installation
- Installation dimensions
- Limiting the opening angle of the appliance door
- Changing the door hinges
- Building in the appliance
- Preparing the appliance
- With 5/8" (16 mm) thick cabinet walls only:
- Building in the appliance
- Securing the appliance in the niche
- Only for an appliance with a niche height greater than 55" (140 cm)
- Installing the cabinet door
- Adjusting the position of the door
- X: side adjustments
- Y: height adjustment
- Z: depth adjustment
- Water connection
- Electrical connection
Installation
*INSTALLATION*
64
Door panel
The required door panel must be min.
5/8” (16mm) and max. 3/4” (19mm)
thick.
–Weight of the door panel
If the door panel is too heavy
damage can occur.
Installing a door panel which is heav-
ier than the maximum permitted
weight could damage the hinges.
This can cause subsequent func-
tional problems.
Before installing the door panel, en-
sure that the weight of the door
panel does not exceed the maximum
permitted weight.
Before installing the cabinet door, en-
sure that the weight of the door does
not exceed the maximum permitted
weight.
Appliance Maximum weight
of cabinet door in
lbs (kg)
FNS 37492 iE 57 (26)
Before installing the appliance
Before installation, remove the bag of
installation and other accessories
from the appliance and remove the
profile strip from the outer appliance
door.
Do not remove the following from
the back of the appliance
- the spacers (depending on the
model). They ensure the distance re-
quired between the back of the appli-
ance and the wall.
- the bags located in the metal grille
(heat exchanger, depending on
model).
These are required for the functioning
of the appliance. Their contents are
not toxic or hazardous.
Remove the cable clips from the back
of the appliance.