Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Saving energy
- Guide to the appliance
- Switching on and off
- The correct temperature
- Using SuperFrost
- Temperature and door alarm
- Selecting additional settings
- Freezing and storing food
- Adjusting the interior fittings
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Information for dealers
- Installation
- Installation
- Installation dimensions
- Limiting the opening angle of the appliance door
- Changing the door hinges
- Building in the appliance
- Preparing the appliance
- With 5/8" (16 mm) thick cabinet walls only:
- Building in the appliance
- Securing the appliance in the niche
- Only for an appliance with a niche height greater than 55" (140 cm)
- Installing the cabinet door
- Adjusting the position of the door
- X: side adjustments
- Y: height adjustment
- Z: depth adjustment
- Water connection
- Electrical connection
Frequently Asked Questions
52
Message Possible cause and solution
The ice cube maker
and alarm symbols
are flashing on the dis-
play. The indicator light
on the ice cube maker
is also flashing.
There is a fault with the ice cube maker.
Contact Miele Service.
The power failure sym-
bol, appears in the
display and the alarm
sounds.
The temperature display
will show the warmest
temperature recorded in
the freezer during a
power failure or an in-
terruption to the power
supply.
There is a power failure: The temperature in the ap-
pliance over the last few days or hours has risen too
high because of a power failure or interruption to the
power supply.
The appliance will go back to the last temperature
setting when the power is restored.
Press the OK button.
The warmest temperature displayed will disappear.
The display will then revert to showing the current
temperature in the freezer section.
Depending on the temperature displayed, you
should check whether food in the freezer has
started to thaw or has defrosted. If it has, cook it
before freezing it again.
The symbol has lit up
on the display and the
appliance is not cooling
although the controls
and the interior lighting
are working.
Demo mode is on. This allows the appliance to be
presented in the showroom without the cooling sys-
tem being switched on. Do not activate this setting
for domestic use.
Turn off demo mode (see “Information for dealers -
Demo mode”).