Operating and Installation instructions

Cleaning and care
43
Rinsing the ice cube maker
 Risk to health due to contami-
nated water.
Bacteria can develop in water which
has been sitting in the water supply
lines for several days. This poses a
risk to your health.
Rinse out the ice cube maker and
water supply line:
–before using for the first time,
–if the ice cube maker has not been
used for a long time (more than
5days),
–regularly when in continuous use
(at least once a month) to remove
residual ice from the system (to avoid
blocking the water supply line),
–before switching the ice cube
maker off for a long time.
After selecting the “Rinse the ice cube
maker” setting, the ice cube maker
and the water supply pipework will be
rinsed automatically with water.
The ice cube tray then moves to the
cleaning position so that it can be dried
by hand.
The water collects in the ice cube
drawer .
Check that the ice cube drawer is
empty before selecting “Rinse the ice
cube maker”. Otherwise, the water will
empty onto the contents of the
drawer.
“Rinse the ice cube maker” can only
be selected when the ice cube maker
is on.
 Touch the settings button.
All symbols available for selection will
appear on the display and the sym-
bol will flash.
 Touch the buttons for setting the tem-
perature ( and ) repeatedly until
the symbol for the ice cube maker 
flashes on the display.
 Touch the OK button to confirm your
selection.
 By touching the and  buttons,
you can now select the setting you
want:
0: The ice cube maker is switched off
1: The ice cube maker is switched on
2: Set the water volume
3: Select the ice cube tray cleaning
position
4: Rinse the ice cube maker
 Touch the OK button to confirm your
selection.
The selected setting is saved. The ice
cube maker symbol in the display
and the indicator light on the ice cube
maker will flash while the ice cube
maker is being rinsed.