Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Saving energy
- Guide to the appliance
- Switching on and off
- The correct temperature
- Using SuperFrost
- Temperature and door alarm
- Selecting additional settings
- Freezing and storing food
- Adjusting the interior fittings
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Information for dealers
- Installation
- Installation
- Installation dimensions
- Limiting the opening angle of the appliance door
- Changing the door hinges
- Building in the appliance
- Preparing the appliance
- With 5/8" (16 mm) thick cabinet walls only:
- Building in the appliance
- Securing the appliance in the niche
- Only for an appliance with a niche height greater than 55" (140 cm)
- Installing the cabinet door
- Adjusting the position of the door
- X: side adjustments
- Y: height adjustment
- Z: depth adjustment
- Water connection
- Electrical connection
IMPORTANT SAFETY INSTRUCTIONS
11
Transport
To avoid damage to the appliance, always transport it upright and
in its packaging.
Risk of injury and damage. The refrigeration appliance is very
heavy and must be transported by 2people.
Disposal of your old appliance
Children could become trapped in the machine and could suffo-
cate.
- Remove the machine doors.
- Remove the drawers.
- Leave the adjustable shelves in the machine so children cannot
climb inside.
DANGER of electric shock!
- Cut the plug off the power cord.
- Cut the power cord off the old appliance.
Dispose of them separately from the appliance.
Ensure that the appliance is not stored in the vicinity of gasoline or
inflammable gases and liquids during and after disposal.
Make sure that the coolant pipework is not damaged during dis-
posal to avoid uncontrolled leakage of oil and coolant (see data plate
for coolant type).
Splashes of coolant can cause damage to the eyes. Be careful not
to damage any part of the pipework while awaiting disposal, e.g. by
- puncturing the coolant channels in the evaporator,
- kinking any pipework,
- scratching the surface coating.