Operating & Installation Guide

Table Of Contents
Energy-saving tips
65
Cooking programs
- Remove all accessories from the
oven that are not required for a cook-
ing program.
- If a temperature range is given, it is
best to select the lower temperature
and check the food after the shortest
cooking time given.
- Preheat the oven only if instructed to
do so in the recipe or the cooking
chart.
- Try not to open the door when cook-
ing.
- Dark, matte tins are best for baking.
They absorb the heat more effectively
and transmit it to the mixture more
quickly. Shiny materials such as
stainless steel or aluminum reflect the
heat and therefore can give a more
uneven result. Do not cover the oven
floor or the wire rack with heat-re-
flecting aluminum foil.
- Monitor cooking durations to avoid
wasting energy when cooking.
Set the cooking duration, or use a
food probe if you have one.
- Most food can be cooked using Con-
vection Bake or Convection
Roast. Because the fan distrib-
utes the heat in the oven compart-
ment straight away, it allows you to
use a lower temperature than you
would with Surround. It also en-
ables you to cook on multiple shelf
levels at the same time.
- Convection Broil is the best operat-
ing mode for broiled dishes. Lower
temperatures can be used than with
other broil modes that use the maxi-
mum temperature setting.
- Whenever possible you should cook
several dishes at the same time.
Place them next to each other in the
oven or on different shelf levels.
- Dishes which you are unable to pre-
pare at the same time should, if pos-
sible, be cooked one after the other
in order to make use of existing heat
in the oven.
Settings
- Select the Display| QuickTouch|
Offsetting for the control elements in
order to reduce energy consumption.
- Select the Lighting| Off or “On” for 15
secondssetting for the oven interior
lighting. You can turn the oven inte-
rior lighting on again at any time by
tapping the Lightsensor button.
Energy-saving mode
The steam oven will turn itself off auto-
matically to save energy if a program is
not being run and controls have not
been operated. The time of day will ap-
pear on the display or the display will
remain dark (see “Settings”).