Installation instructions Information is subject to change. Please refer to our website to obtain the most current product specification, technical & warranty information. The installation steps are described in the enclosed "Installation Diagram". Leave these instructions with the appliance for the consumer/user. Information is subject to change. Please refer to our website to obtain the most current product specification, technical & warranty information.
Caring for the environment Disposal of packing material Disposal of an old appliance The cardboard box and packing materials protect the appliance during shipping. They have been designed to be biodegradable and recyclable. Please recycle. Old appliances may contain materials that can be recycled. Please contact your local recycling authority about the possibility of recycling these materials. Ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of the reach of children.
Plumbing The machine must be connected to the water supply in accordance with local and national regulations. Disconnect the machine from the electrical supply before connecting it to the water supply. Turn off the water supply before connecting the coffee machine to the plumbing. – All units and systems used to deliver the water to the coffee system must conform with the requirements of the respective country.
Plumbing Installing the stainless steel tubing in the unit Make sure the stainless steel tube is not kinked or damaged. Do not trim stainless steel tube. ^ Remove the water connection cover at the lower rear side of the coffee machine. ^ Take the angled side of the stainless steel tube and check whether the sealing ring is in place. If necessary, insert it. Connection to the water supply Disconnect the machine from the electrical supply before connecting it to the water supply.
Lead free certificate This product is tested and certified by the WQA against ORD0902 for California "lead free" compliance.
Electrical connection Make sure that the power to the machine is OFF before installing or performing maintenance or repairs. WARNING: THIS APPLIANCE MUST BE GROUNDED Important All electrical work should be performed by a qualified electrician in strict accordance with national and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous.
Installation Installation and combination options The system is designed to be built into cabinetry.
Installation It is also possible to combine it with other built-in Miele appliances. If the coffee system is to be built in above another appliance, there must be a full-width, closed shelf between them (exception: installation with a built-in warming drawer).
Installation Ventilation When installing the coffee system, make sure that it is sufficiently ventilated at the back so that steam and hot air can escape. The ventilation openings in the surrounding cabinets and the space below the ceiling must be at least 78 3/4"² (200 cm²). Otherwise condensation can form, causing damage to the coffee system or the surrounding cabinets.
Installation Tip: A place to set down the coffee machine at the level of the installation recess is helpful. This makes it easier for you to install the unit's electrical and water connections. ^ Unscrew the four feet on the underside of the unit by about 1/16" (2 mm) using the larger Allen wrench. The coffee machine is delivered with four M5 Allen head screws that you can use to align and fasten the unit in the installation recess. ^ Open the door and partially tighten the screws.
Installation Adjusting the door hinges If the door cannot be opened or closed easily after installation, you will have to align the door (TX 20): ^ To adjust the door flush with the front of the cabinet, turn the screw a. ^ To adjust the door horizontally and vertically, turn the screw b.
RemoteVision (optional accessory) Miele's RemoteVision Wi-Fi technology creates a 'virtual link' between your appliance and our monitoring center. If a fault occurs, Miele's client service center will be notified and contact you, or another trusted individual identified on your call roster, in order to gain access to your appliance to fix the problem. For information on set-up and installation of the RemoteVision module see the "Installation" section of this manual.
Copyright and licenses Miele uses software to operate and control the coffee system. This product contains Adobe® Flash® Player software under license from Adobe Systems Incorporated, Adobe Macromedia Software LLC. Adobe and Flash are registered trademarks of Adobe Systems Incorporated. The proprietary rights of Miele and other relevant software suppliers (e.g. Adobe) must be respected. Miele and its suppliers reserve all rights to the software components.
92
93
94
Please have the model and serial number of your appliance available before contacting Technical Service. U.S.A. Canada Miele, Inc. Importer Miele Limited National Headquarters 9 Independence Way Princeton, NJ 08540 Phone: 800-843-7231 609-419-9898 609-419-4298 Fax: www.mieleusa.com Technical Service & Support Nationwide Phone: 800-999-1360 888-586-8056 Fax: TechnicalService@mieleusa.com Headquarters and Miele Centre 161 Four Valley Drive Vaughan, ON L4K 4V8 www.miele.
CVA 6805 en - US, CA M.-Nr.