manual

Installation
91
Installing the coffee system
Make sure that there is no power to
the machine during installation. This
also applies when uninstalling.
The machine may only be operated
when installed and in an ambient
t
emperature range between +50°F
(10°C) to +100°F (38°C).
For installation, you will require two
soc
ket wrenches in sizes 3 and 5.
To ensure the appliance door is flush
with the cabinetr
y front, a seal around
the building-in niche is needed or a
sealing strip must be adhered to the
coffee system.
 If ther
e is not a seal at the front of the
building-in niche, adhere the Miele
sealing strips from the back (see pic‐
ture) before installing the coffee sys‐
tem.The sealing strips can be pur‐
chased from Miele.
Sealing strips are available from your
Miel
e dealer or from Miele.
Tip: W
e recommend providing a place
to sit the coffee system which is the
same height as the building-in niche.
This will make it easier to connect the
machine to the electrical supply.
 Usin
g the large allen key, unscrew all
four feet out by about 3/4" (2 mm).
.The feet can be unscrewed by up to
appr
ox. 4" (10 mm).
 Co
nnect the appliance to the electri‐
cal supply.
Ensure the power cord does not get
damaged when pushing the appli‐
anc
e into the niche.
 P
ush the coffee system all the way
into the building-in niche.
 Mak
e sure the coffee system is cen‐
tered and straight in the building-in
niche. If this is not the case, align the
machine using the four bases.