Coffeemaker User Manual

ManualsBrandsMiele ManualsCoffee MakerCVA 4070 EN-CA

Installation Instructions

CVA 4070 en-CA

Installation, repair and maintenance work should be performed by

a Miele authorized service technician in accordance with national

and local safety regulations and the provided installation instructions.

Summary of content (6 pages)

PAGE 1
Installation Instructions CVA 4070 en-CA Installation, repair and maintenance work should be performed by a Miele authorized service technician in accordance with national and local safety regulations and the provided installation instructions.
PAGE 2
Electrical connection Important Ensure that power is not supplied to the machine while installation or maintenance work is performed. All electrical work should be performed by a qualified electrician in strict accordance with national and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous. The coffee system comes equipped with a 6 ft (1.8 m) power cord with a NEMA 5-15P molded plug for connection to a 120 V, 15 A, 60 Hz power supply.
PAGE 3
Installation Installation options The coffee system is designed to be built into cabinetry. A combination with other Miele built in appliances is possible. If the machine is installed in combination with other appliances, it should be installed with a protective base between the appliance and the unit (exception: installation with a built-in plate warmer). A special display cabinet is also available from your dealer or Miele, as an installation option. Miele appliances can be installed flush or proud.
PAGE 4
Installation Installation Make sure power is not supplied to the appliance while installation or maintenance work is performed. Disconnect the power supply to the work area by unplugging the unit, tripping the circuit breaker or removing the fuse. The coffee system must be installed into cabinetry before being used. ^ If your cabinet has 3/4" (19 mm) side walls, drill four holes for the mounting. ^ Center the unit and turn the screws a little bit in and then out again.
PAGE 5
Installation Adjusting the door hinges The door hinges can be adjusted if the door cannot be opened easily. ^ To adjust the door sideways, a, turn screw a. ^ To adjust the door to the front or back, b, turn screw b.
PAGE 6
Alteration rights reserved / 0607 CVA 4070 For the most updated manual see the MIele Website. M.-Nr.