Operating Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Machine description
- Controls and indicators
- Operation
- Miele@home
- Before first use
- Filling the water tank
- Filling the coffee bean container
- Switching on and off
- Cup heating
- Adjusting the coffee dispensers to the cup height
- Preparing beverages
- Expert Mode
- Grinder setting
- Parameters
- Profiles
- MobileStart
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Clean by hand or in dishwasher
- Unsuitable cleaning agents
- Drip tray and grounds container
- Cleaning the drip tray cover
- Water container
- Removing and cleaning the water container filter
- Dismantling and cleaning the main dispenser
- Cleaning the steam jet
- Cleaning the milk pipework and rinse valve
- Cleaning the milk siphon
- Cleaning the milk flask
- Bean container and ground coffee chute
- Cleaning the casing
- Accessing the Maintenance menu
- _
- Rinsing the milk pipework
- Cleaning the milk pipework (maintenance program)
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Frequently Asked Questions
- Transport
- Service and warranty
- Accessories
- Saving energy
- Electrical connection
- Installation
- Appliance dimensions
- Technical data
Frequently Asked Questions
79
Unsatisfactory results
Problem Possible cause and solution
The coffee is not hot
enough.
The cup has not been pre-heated.
The smaller the cup and the thicker its sides, the
more important it is to pre-heat it.
Pre-heat the cup, e.g. using the cup heater
(depending on model).
The brewing temperature is set too low.
Set a higher brewing temperature.
The filters in the brew unit are blocked.
Remove the brew unit and clean it by hand.
Degrease the brew unit.
Heating-up is taking
longer. The amount of
water is no longer cor-
rect and the coffee ma-
chine is not performing
properly. Coffee flows
into the cup very slowly.
The coffee machine needs to be descaled.
Descale the coffee machine.
The amount of coffee
dispensed has changed.
The brew unit is blocked.
Degrease the brew unit (see “Cleaning and care –
Degreasing the brew unit and cleaning the
interior”).
The consistency of the
milk froth is unsatisfac-
tory.
The milk temperature is too high. Good milk froth can
only be achieved when cold milk (below 50°F/10°C)
is used.
Check the temperature of the milk in the milk flask.
The milk pipe is blocked.
Clean the main dispenser and milk pipework with
the brush.
The coffee grinder
makes a louder noise
than usual.
The coffee bean container has become empty during
the grinding process.
Fill the coffee bean container with fresh beans.
There may be foreign objects such as plastic or
stones in amongst the coffee beans.
Switch the coffee machine off immediately.
Contact the Technical Service department.