Operating Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Machine description
- Controls and indicators
- Operation
- Miele@home
- Before first use
- Filling the water tank
- Filling the coffee bean container
- Switching on and off
- Cup heating
- Adjusting the coffee dispensers to the cup height
- Preparing beverages
- Expert Mode
- Grinder setting
- Parameters
- Profiles
- MobileStart
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Clean by hand or in dishwasher
- Unsuitable cleaning agents
- Drip tray and grounds container
- Cleaning the drip tray cover
- Water container
- Removing and cleaning the water container filter
- Dismantling and cleaning the main dispenser
- Cleaning the steam jet
- Cleaning the milk pipework and rinse valve
- Cleaning the milk siphon
- Cleaning the milk flask
- Bean container and ground coffee chute
- Cleaning the casing
- Accessing the Maintenance menu
- _
- Rinsing the milk pipework
- Cleaning the milk pipework (maintenance program)
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Frequently Asked Questions
- Transport
- Service and warranty
- Accessories
- Saving energy
- Electrical connection
- Installation
- Appliance dimensions
- Technical data
Frequently Asked Questions
77
Problem Possible cause and solution
The milk sputters when
it is dispensed. Hissing
noises can be heard
when milk is being
heated up or frothed.
Although the milk
should be frothed, only
hot milk comes out of
the main dispenser.
The milk pipework was not correctly inserted.
Pay attention to the seam on the double hose
when you connect the milk pipework into the main
dispenser.
If you have disconnected the milk pipework from
the rinse valve: the double hose has different
diameters. Make sure all parts are assembled
correctly.
The milk temperature is too high. Good milk froth can
only be achieved when cold milk (below 50°F/10°C)
is used.
Check the temperature of the milk.
The main dispenser is not correctly mounted and is
taking in air. Or the spouts are blocked.
Check whether the main dispenser is correctly
assembled. Make sure that all parts are tightly
connected to one another.
Clean the main dispenser. Rub the spouts under
running water to remove any dirt.
The milk pipework, connecting pieces, the stainless
steel tube of the milk flask, or the milk siphon are
blocked.
Clean all parts carefully with the cleaning brush.
The steam jet on the main dispenser has a blockage.
Clean the steam jet with the cleaning brush (see
illustration).