Operating & Installation Guide

en - Cleaning and waxing recommendations
10
 Lay the cleaning cloth on the left side of the infeed table with the
cleaning strip facing the heater plate.
 Feed the cleaning cloth evenly and straight from the left side of the
infeed table through the ironer until it comes all the way out on the
other side.
The cleaning strip loosens the soiling. The softer cotton strip removes
the soiling and polishes the heater plate.
 Lay the cleaning cloth back on the infeed table, but this time move
it slightly to the right. The cleaning and cotton strips are facing the
heater plate again.
 Feed the cleaning cloth through the ironer again.
 Repeat the process until you reach the right side of the infeed table
and the entire width of the heater plate has been cleaned.
It is essential to wax the heater plate after cleaning!
Staggered feeding of the cleaning cloth from the left to the right side of the heater plate.
Replacing the
used cleaning
strip
 Remove the used cleaning strip from the cleaning cloth pocket.
After removing the cleaning strip, you can wash the cleaning cloth
(Cottons 95°C).
 Cut a new cleaning strip (approx. length of 210mm) from the clean-
ing mat Mat. no. 03987592.
A total of three new cleaning strips can be cut from the cleaning mat
(Mat .no. 03987592).
 Insert the new cleaning strip into the pocket of the cleaning cloth.
Optional ac-
cessories
The following accessories are available for cleaning and caring for the
heater plate:
– Miele Nomex nettle cleaning cloth with pocket: Mat. no.03909300
(Max. temperature approx. 80°C, ironer symbol “”, lowest roller
speed)
– Miele “SMR” starter kit: Mat. no.07356090