Operating and Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Installation information
- Installation dimensions
- Building in the appliance
- Before starting...
- Tools required
- Aligning the installation niche
- Checking the installation space
- Before installation
- Preparing the installation niche
- Pushing the appliance into the niche
- Aligning the appliance
- Securing the appliance in the niche
- Securing the base cover plate and the baseboard
- Aligning the appliance doors
- Adjusting the door opening angle (optional accessory)
- Electrical connection
- Water connection
- How to save energy
- Guide to the appliance
- Accessories
- Before first use
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Automatic SuperCool and SuperFreeze
- Temperature and door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Water filter
- Technical Service
- Declaration of conformity
- Leere Seite
Building in the appliance
27
Before starting...
It is essential to read these installa-
tion instructions carefully before
starting to install the appliance.
The appliance should be installed by
a suitably qualified tradesman in ac-
cordance with these installation in-
structions. Safe operation of the ap-
pliance is only assured if it has been
installed and connected in accor-
dance with the installation instruc-
tions.
Risk of damage and injury!
This appliance is very heavy and can
tip forwards when the door is open.
Keep the appliance door shut until
the appliance has been built in and
secured in its housing in accordance
with the operating and installation in-
structions.
The appliance is both large and
heavy. Installation must be carried
out by two people.
The appliance must be installed in ac-
cordance with local regulations. If local
regulations are not available, the follow-
ing regulations must be observed:
– in the USA: the National Electric
Code, ANSI/NFPA 70 - latest edition/
State and Municipal codes and/or lo-
cal codes.
– in Canada: the Canadian Electric
code C22.1 - latest edition/Provincial
and Municipal codes and/or local
codes.
Tools required
– Cordless drill
– TX20 screwdriver
– Hammer drill
– Drill bits in various sizes, depending
on materials
– Hammer
– Open-ended wrench
– Ratchet wrench, attachment: socket,
5/16" (8mm)
– Adhesive tape
– Utility knife
– Pipe wrench
– Level
– Tape measure
– Pencil
Other
– Step ladder
– Hand truck