Integration Instruction

ManualsBrandsMiele & Cie ManualsElectronicsEPI7684, radio module for wireless food probe system

2022-03-18

Manual for EPI7684, the wireless food probe system

1 General

The wireless food probe system consists of the radio module (EPI7684), antenna system and the wireless

food probe. This system enables the roasting process of the food to be monitored simple and reliably. The

wireless food probe will be here not described because it is a passive device and does not matter for the

installation of the system.

The wireless food probe system may be installed in the Miele domestic appliances like ovens or steam

cooker (host devices)

Integration instruction

The EPI7684 and the loop antenna must be integrated under consideration of the technical data. It is not

allowed to make any changes on the module or use another antenna.

2 Technical data EPI7684 and antenna

VCC in V

13,0 and 3,3 DC

Current in mA

170 max.

Ambient temperature in °C

0-85

Humidity max

90%

Non condensation

Dimensions in mm

105x80

Wireless

Antenna type

external loop antenna

Antenna gain

-7dBi

Frequency band

2400 MHz - 2483.5 MHz

Method of transmitting radio signal

FHSS

Channels

600

Transmission Power in mW

<100

2.1 Interface to the control-/ power electronic of the host device

On the control-/ power electronic is a 4-pin rast 2.5 plug and on the EPI site is 8-pin rast 2.5 plug. This

connection includes communication and power supply wire (13 and 3,3V DC)

Summary of content (5 pages)

PAGE 1
2022-03-18 Manual for EPI7684, the wireless food probe system 1 General The wireless food probe system consists of the radio module (EPI7684), antenna system and the wireless food probe. This system enables the roasting process of the food to be monitored simple and reliably. The wireless food probe will be here not described because it is a passive device and does not matter for the installation of the system.
PAGE 2
022-03-18 3 3.1 Norms / Standards FCC / IC FCC regulation: FCC 47 CFR Part 15.247 Part 1.1310 Part 1.1091 IC regulation: RSS-247, Issue 2 RSS-Gen, Issue 5 RSS-102, Issue 5 3.
PAGE 3
2022-03-18 Picture 2: label of the module Picture 3: loop antenna, FAKRA-connector 4 Compliance Statement and Integration In accordance with FCC 47 CFR Part 15 and RSS-247, Issue 2, the EPI7684 (FCC ID: SSVNAEPI03; IC: 5669B-EPINA03) is listed as a Modular Transmitter Device. Notice: This device complies with Part 15 of the FCC Rules and contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS Standarrd(s).
PAGE 4
2022-03-18 Radiofrequency radiation exposure Information: This equipment complies with FCC radiation exposure limits set forth and Canada radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
PAGE 5
2022-03-18 Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. 4.