Alan 48 Pro ” GUIDA ALL‘USO ” INSTRUCTION GUIDE ” BEDIENUNGSANLEITUNG ” MANUAL DE INSTRUCCIONES ” G U I D E D ‘U T I L I S AT I O N ” INSTRUKC JA OBSŁUGI ” MANUAL DE UTILIZARE
INDEX Introduction .......................................................................................................................................................................................................................................................Pag. 1 Installation .................................................................................................................................................................................................................................
FUNCTION AND LOCATION OF THE CONTROLS 1. Channel selector 2. Microphone jack: Insert the mic connector into this jack. 3. Multifunction backlighted display. 4. The icons of the display and their description may vary depending on the production lot. 5. 6. 7. 8. 2 A. Channel selected number B. The received signal strength and the power of the transmitting signal C. AM/FM mode. These icons blink if the NOISE BLANKER function has been activated (version without NB and DS displayed). D.
a. Select the desired channel through the channel selector. b. Press the “DW” button (DW blinks on the display). c. Select the second channel. d. Push the “DW” button again: the reading DW will remain fixed. e. To disable this function, press the “DW” control. REAR PANEL UK and press M1 for at least 3 sec to store the choosen channel in the M1 memory. Repeat these steps to memorise the other presets. 9. EMG button: Emergency channel.
MICROPHONE INSTALLATION 1. PTT: transmission button 2. UP/DOWN buttons: manual channel selector 3. LOCK button: it allows you to lock the UP/DOWN buttons. 4. 6 pin microphone connector Safety and convenience are the primary consideration for mounting any piece of mobile equipment. All controls must be readily available to the operator without interfering with the movements necessary for safe operation of the vehicle.
If you replace the fuse for DC power Cord, use F 2A 250V type. The parameters and the symbol of the fuse are indicated in the following label. F2A 250V + HOW TO OPERATE WITH YOUR TRANSCEIVER 1. Screw the microphone plug into the microphone jack. 2. Make sure your antenna is securely connected to the antenna connector. 3. Make sure the SQUELCH control is turned fully counterclockwise. 4. Turn on the unit and adjust the volume control. 5. Select your desired channel. 6.
TECHNICAL SPECIFICATIONS GENERAL Channels .............................................................(see the frequency band chart) Frequency Range* ....................................................... 26.565 - 27.99125 MHz Duty cycle (% on 1 hour) ................................ TX 5% - RX 5% - Stand-by 90% Frequency Control ...........................................................................................PLL Operating Temperature Range ......................................................