Operating Instructions

INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
CONNECTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
PROGRAMMING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
MIDI CHANNEL TABLE . . . . . . . . . . . . . . . . . . . . . . . 19
MIDI CONTROL CHANGE TABLE . . . . . . . . . . . . . . . 21
HEXADECIMAL CONVERSION TABLE . . . . . . . . . . . 25
WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
.
MIDI Solutions Router
Operating Instructions M201
c
2001 MIDI Solutions, Inc.
All Rights Reserved
Printed in Canada
MIDI Solutions, Inc.
P.O. Box 3010
Vancouver, BC Canada V6B 3X5
www.midisolutions.com
To program the Router, connect the In of the Router to the
MIDI Out of the device that is sending the programming
commands. Out1 and Out2 can be left disconnected during
programming. Once the Router is programmed, it can be inserted
anywhere in your MIDI setup. Connect the In of the Router to the
MIDI Out or Thru of the sending MIDI device. Connect Out1 of the
Router to the MIDI In of the first receiving MIDI device. Connect
Out2 of the Router to the MIDI In of the second receiving MIDI
device. It is recommended that the number of MIDI Solutions
products chained together between any two MIDI devices be
limited to five.
7
TM
6
Congratulations on your purchase of the MIDI Solutions
Router. The MIDI Solutions Router has the capability of routing
selected MIDI messages to either of two MIDI outputs. Routing
capabilities include Note, Polyphonic Key Pressure, Control
Change, Program Change, Channel Pressure, Pitch Bend, and
System messages, on all or selected MIDI channels. Up to 10
settings may be stored by the Router. Programmed settings are
retained in non-volatile memory until cleared or overwritten with
new settings. The Router is MIDI-powered and requires no
batteries or power supply to operate.
5
3