Product Specs

manual

Product Specifications

1. Product model: HTMS1 Microsone - Light

2. Bluetooth version: BT V5.0

3. Signal distance: 10m

4. Use time: 5 Hours

5. Charging time: 1 hour

6. Support mode A2DP/AAC/ADC/AG/AVRCP/GAIA/HFP/PBAP/PDL/RSSI/

SBC/SCO/SIG

Function Description

1. Power on: Take out the earphones from the charging compartment, you can connect

the Bluetooth device and use it.

2. Manual pairing is required for the first use, and automatic pairing is required for

subsequent use.

3. The two earbuds work independently.

Charging Instructions

1. Use the Type-C charging cable to charge the charging box. The power of the charging

box corresponds to the number on the display.

2. Charge the earphones: Put the earphones into the charging box, the marquee light on

the display flashes, which proves that the earphones are charging. When the marquee

stops flashing, the headset is fully charged.

FCC WARNING

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation .

Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

PAGE 1
manual Product Specifications 1. Product model: HTMS1 Microsone - Light 2. Bluetooth version: BT V5.0 3. Signal distance: 10m 4. Use time: 5 Hours 5. Charging time: 1 hour 6. Support mode A2DP/AAC/ADC/AG/AVRCP/GAIA/HFP/PBAP/PDL/RSSI/ SBC/SCO/SIG Function Description 1. Power on: Take out the earphones from the charging compartment, you can connect the Bluetooth device and use it. 2. Manual pairing is required for the first use, and automatic pairing is required for subsequent use. 3.
PAGE 2
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.