User's Manual

4225 Executive Square, Suite 430 La Jolla, CA 92037
www.micropowerapp.com
Mono Camera Module Installation Guide
This document outlines requirements and guidelines for installing the Mono Camera Module P/N
370-00012-01 into MicroPower equipment. The Mono Camera Module is not approved for
individual sale, and must always be installed and operated according to the following
requirements.
Labeling. The equipment into which the Mono Camera Module is installed must contain an
external label. The label shall contain the following information:
Contains FCC ID: ZHX-370-00012-01
This device complies with Part 15 of the FCC rules subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept all interference received, including interference that may cause
undesired operation.
Antennas: The equipment into which the Mono Camera Module is installed must satisfy the
following antenna requirements:
1) Only antennas listed in the current FCC filing may be used with the equipment.
2) The antennas must be attached to the equipment with unique connectors, or the
equipment must be professionally installed by trained personnel such that compliance
with the FCC filing is maintained.
Shielding: The enclosure for the Mono Camera Module shall not be modified or removed.