CDMA/GPS Tracker Prime One X User Manual Revision: 1.00 Document Title Version Finale Date Status Document Control ID Prime One X User manual 1.
Contents 1 Introduction...................................................................................................................................... 3 2 Product Overview............................................................................................................................ 3 2.1 Appearance............................................................................................................................3 2.2 Buttons/12PIN Interface Description............................
1 Introduction Prime One X is a powerful GPS locator which is designed for vehicle, human, pets and assets tracking , including emergency call function meanwhile(e.g. a wearable product). With superior receiving sensitivity, fast CDMA frequencies 850/1900. Its location can be real time or schedule tracked by backend server or specified terminals.
Function Button Geo-Fence mode Long press the key to enable/disable Geo-Fence ID0 Geo-Fence in current position mode Long press the key to enable/disable Geo-Fence ID0. If enable Geo-Fence ID0, using the current position as the centre of Geo-Fence 0. SOS mode (default) Long press the key to active SOS alarm 12PIN interface(USB port) Connect a 5V DC adapter can power on Prime One X and charge the internal battery Connect a 3.
Figure 2-3 3 Getting Started 3.1 Parts List Name Picture Remark Prime One X Locater The CDMA/GPS locator. AC-DC Power Adapter It is used to charge the internal battery of Prime One X. Prime One X Data and charger Cable It the data cable which can be used for firmware upgrading and configuration. It also includes the charger interface on the Prime One X (by RD or engineer not by end user)..
3.2 Battery Charging The following items are suggestion for battery charge, please pay more attention. Please connect AC-DC power adapter with Prime One X device. Insert the AC-DC power adapter into the power socket. During the charging process, the Power LED light will solid. When the battery is fully charged, the Power LED light will be Ever-light. You can also charge the battery using charging cable which connects Prime One X device with the Adapter. Charging will last about 5 hours.
Power off: Press the power button about 3 seconds; Power LED light will fast flash and then turn off, which indicates that Prime One X device has been powered off. Note: the user can not power off Prime One X if the power key is disabled by protocol. 3.5 Insert SIM Card Figure 3-3 3.
4 Trouble shooting and Safety info 4.1 Trouble shooting Trouble Possible Reason Solution Messages can’t be reported to the backend server by Mobile network. APN is wrong. Some APN can not visit the internet directly. Ask the network operator for the right APN. The IP address or port of the backend server is wrong. Make sure the IP address for the backend server is an identified address in the internet. Unable to power off Prime One X. The function of power key was disabled by AT+GTFKS.
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. § 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. § 15.105 Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.