GSM/GPRS/GPS Tracker Prime AT Plus User Manual Revision: 1.04 Document Title Prime AT Plus User manual Version 1.
Contents 1 Introduction .................................................................................................................................... 3 2 Product Overview .......................................................................................................................... 3 2.1 Appearance .......................................................................................................................... 3 2.2 Buttons/Mini USB Interface Description ..........................
1 Introduction Prime AT Plus is a powerful GPS locator which is designed for vehicle, pets and assets tracking. With superior receiving sensitivity, fast TTFF and GSM frequencies 850/900/1800/1900. Its location can be real time or schedule tracked by backend server or specified terminals.
Power Key Power on Prime AT Plus Power off Prime AT Plus (If power key is enabled) Function Key Geo-Fence mode Long press the key to enable/disable Geo-Fence ID0 Geo-Fence in current position mode Long press the key to enable/disable Geo-Fence ID0. If enable Geo-Fence ID0, using the current position as the centre of Geo-Fence 0. SOS mode (default) Long press the key to active SOS alarm Mini USB interface Connect a 5V DC adapter can power on Prime AT Plus and charge the internal battery Connect a 3.
In charging Slow flash (red) Power key was pressed and prepare to power off Fast flash (red) Power key was pressed and prepare to power on Fast flash (green) 2.4 External Power Interface 2.4.1 External DC Charger Interface The Pin2 on Mini-USB connector is used for charging and named as VCHG pin, which can be connected to 5V DC power source to power on Prime AT Plus device and charge the current battery. Figure 1-3 PIN NO.
2.4.2 External Battery Interface The Pin 8 and Pin9 on Mini-USB connector are used for external battery and named as EXTBAT pin, which can be connected to 3.7V Li-ion or Li-Polymer battery to power on Prime AT Plus device. The Pin6 on Mini-USB connector is used for external battery interrupt detection and named as EXT_VBAT INT, which must be connected to GND for EXT_VBAT detection. Figure 1-4 PIN NO.
3 Getting Started 3.1 Parts List Name Picture Remark Prime AT Plus Locater The GSM/GPRS/GPS locator. AC-DC Power Adapter It is used to charge the internal battery of Prime AT Plus. Prime AT Plus Data and charger Cable It the USB data cable which can be used for firmware upgrading and configuration. It also includes the charger interface on the Prime AT Plus. 3.2 Battery Charging The following items are suggestion for battery charge, please pay more attention.
3.3 Prime AT Plus Data Cable Prime AT Plus Data Cable is a cable with a Mini USB connector. The USB data cable is used for data download, which will be used for firmware update or configuration and can be used for charging at the same time. Figure 2-1 3.4 How to insert SIM Card Figure 2-2 Step1: Screw off and pull out the cover of SIM card..
shown. Step3: push the cover back. 3.5 Power on/Power off Figure 2-3 Power on: Press the Power key at least 3 seconds and release it to power on Prime AT Plus device. Note that, the Power LED light will fast flash. Power off: Press the power key about 3 seconds; Power LED light will fast flash and then turn off, which indicates that Prime AT Plus device has been powered off. Note: the user can not power off Prime AT Plus if the power key is disabled by protocol. 4 Trouble shooting and Safety info 4.
Prime AT Plus can’t fix GPS successfully. GPS LED flashes slowly. has been locked. battery or apply for after sale help. The GPS signal is weak. Please move Prime AT Plus to a place with open sky. It is better to let the top surface face to the sky. (The same surface with indication LED) 4.2 Safety info The following items are suggestion for safety use, please pay more attention. Please do not disassemble the device by yourself.