LTE Tracker MH 1000V User Manual Revision: 1.00 Document Title MH 1000V User manual Version 1.
1 Introduction ................................................................................................................................... 3 2 Product Overview ........................................................................................................................... 3 2.1 Appearance ......................................................................................................................... 3 2.2 Buttons/12PIN Interface Description........................................
1 Introduction MH 1000V is a powerful GPS locator which is designed for vehicle, human, pets and assets tracking. It works on LTE B4/B13 with superior receiving sensitivity. Its location can be real time or schedule tracked by backend server or specified terminals.
Function Key SOS mode Long press the key to active SOS alarm 12PIN interface Connect a 3.8V Li‐ion or Li‐Polymer battery can power on MH 1000V Backend server developer or administrator can use the data cable to configure MH 1000V (by RD or engineer not by end user). Reset Key Click the key will turn off internal VBAT when OS is abnormal, and then press Power Key to restart MH 1000V. Test Key In the condition of different percentage of battery, Click the key has a corresponding sound. 2.
GPS LED Network has been registered Slow flash No Network Fast flash A call is active Solid GPS signal valid Fast flash GPS turned off, GPS signal invalid Dark Power key was pressed and prepare to power on Solid 3 Getting Started 3.1 Parts List Name Picture Remark MH 1000V Locater The LTE/GPS locator. MH 1000V charging Dock It used to be charging for the MH 1000V. 3.2 Battery Charging The following items are suggestion for battery charge, please pay more attention.
with the Adapter. Charging will last about 5 hours. Note: If the MH 1000V device is firstly used, please make sure the battery is fully charged, which will make the life of battery much longer. 3.3 MH 1000V Charging Dock MH 1000V Charging Dock is a base with an AC Adapter. The charging dock is used for device charging , which can be used for charging at the any time ( by end user)..
3.4 Power on/Power off Figure 2‐2 Power on: Press the Power key at least 3 seconds and release it to power on MH 1000V device. Notethat,thePowerLEDlightwilllightforamoment and then turn off. Power off: Press the power key about 3 seconds; Power LED light will light for a moment and then turn off, which indicates that MH 1000V device has been powered off. Note: the user can not power off MH 1000V if the power key is disabled by protocol. 4 Frequency LTE: Band4 、Band13 GPS: 1575.
Trouble Messages can’t be reported to the backend server by Mobile network. Possible Reason Solution APN is wrong. Some APN can not visit the internet directly. Ask the network operator for the right APN. The IP address or port of the backend server is wrong. Make sure the IP address for the backend server is an identified address in the internet. Unable to power off The function of power key MH 1000V. was disabled by AT+GTFKS. Enable the function of power key by AT+GTFKS.
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ‐Reorient or relocate the receiving antenna. ‐Increase the separation between the equipment and receiver.