LifeGait Motion Sensors User Manual Revision: 1.00 Document Title LifeGait Motion Sensors User Guide Version 1.
Contents 1 Introduction ...................................................................................................................................................... 2 Product Overview ............................................................................................................................................. 2.1 Appearance .......................................................................................................... 3 2.2 Switch/5PIN Interface Description .............
1 Introduction LifeGait Motion Sensors is a Tracker which is designed for getting information of human motion , including WIFI function meanwhile(e.g. a wearable product). With superior receiving sensitivity, WIFI frequencies 2.4GHz. Based on the embedded wireless protocol, LIFEGAIT MOTION SENSORS can communicate with the backend server through WIFI function, and transfer data of sensor, device information etc… 2 Product Overview 2.1 Appearance Figure 1-1 2.
Backend server developer or administrator can use the data cable to configure LIFEGAIT MOTION SENSORS (by RD or engineer not by end user). 2.3 LED Description Figure 1-2 There are Three LED lights in LifeGait Motion Sensors device, the description as following.
3 Getting Started 3.1 Parts List Name Picture Remark LifeGait Motion Sensors LifeGait Motion Sensors USB Cable It is used to charge the internal battery of LifeGait Motion Sensors LifeGait Motion Sensors Data and charger Cable the data cable which can be used for firmware upgrading and debug. It also includes the charger interface (by RD or engineer not by end user). 3.2 Battery Charging The following items are suggestion for battery charge, please pay more attention.
3.3 LifeGait Motion Sensors Data Cable LifeGait Motion Sensors Data Cable is a cable with a 5PIN connector. The data cable is used for data download, which will be used for firmware update or configuration and can be used for charging at the same time (by RD or engineer not by end user). Figure 2-1 3.4 Power on/Power off Figure 2-2 Power on: Push the On/off Switch to the right side then power on LIFEGAIT MOTION SENSORS. Note that, the Power on LED(Blue) light will be solid.
4 Trouble shooting and Safety info 4.1 Trouble shooting Trouble Possible Reason Solution Unable to power off LifeGait Motion Sensors . On/off Switch is damage The device will power off when push the On/off Switch to the left side Battery can not be charged The battery has not been used for too long time and has been locked. Using a external power source with 3.6V to 4.2V DC power supply to active the battery or apply for after sale help. 4.
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.