GSM/WCDMA/GPS Tracker Bolt Mini User Manual Revision: 1.00 Document Title Bolt Mini User manual Version Finale Date 1.
Contents 1 Introduction.................................................................................................................................... 3 2 Product Overview .......................................................................................................................... 3 2.1 Appearance.......................................................................................................................... 3 2.2 LED Description ...................................................
1 Introduction Bolt Mini use primary batteries. it is a powerful GPS locator which is designed for vehicle, and assets tracking . With superior receiving sensitivity, Its location can be real time or schedule tracked by backend server or specified terminals.
2.2 LED Description Figure 2-2 There is one tricolour LED lights in Bolt Mini device, the description as following.
3 Getting Started 3.1 Parts List Name Picture Remark Bolt Mini The GSM/WCDMA/GPS locator. 3.
3.3 WiFi Operation Introduction You can input following command to the serial port. WIFI AT+EWIFI=1 SUCCEED:WiFi Start FAILED::WiFi Start Search WIFI AT+EWIFI=2 Return searchable WiFi wireless hotspot and LASTAPLAST Close WIFI AT+EWIFI=0 SUCCEED:WiFi Stop Connect WIFI AT+WIFI=CONNE CT,mobiletek,3,3, www.mobiletek.cn mobiletek(WiFi name)www.mobiletek.cn (password) Open Note:Input AT+distslp command when device starting up. 3.4 Disassemble Introduction 1.
2.Machine appearance: Figure 3-2 3.Disconnect the screw plug Figure 3-3 4.
5.Tear down the base Figure 3-5 3.5 Insert SIM Card Figure 3-6 3.
3.7 Install Figure 3-8 4 Frequency GSM850(GPRS):824MHz-849MHz(Tx);869MHz-894MHz(Rx) PCS1900(GPRS):1850MHz-1910MHz(Tx);1930MHz-1990MHz(Rx) WCDMA:Band2、Band4、Band5 GPS:1575.
5 Trouble shooting and Safety info 5.1 Trouble shooting Trouble Possible Reason Solution Messages can’t be reported to the backend server by Mobile network. APN is wrong. Some APN can not visit the internet directly. Ask the network operator for the right APN. The IP address or port of the backend server is wrong. Make sure the IP address for the backend server is an identified address in the internet. Unable to power off BOlt Mini. The function of power key was disabled by AT+GTFKS.
FCC Caution. § 15.19 requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. § 15.