GSM/GPRS/GPS Tracker Prime At Lite User Manual Revision: 1.03 Document Title Prime At Lite User manual Version 1.
Contents 1 Introduction....................................................................................................................................3 2 Product Overview ..........................................................................................................................3 2.1 Appearance..........................................................................................................................3 2.2 Buttons/Mini USB Interface Description................................
1 Introduction Prime At Lite is a powerful GPS locator which is designed for vehicle, pets and assets tracking. With superior receiving sensitivity, fast TTFF and GSM frequencies 850/900/1800/1900. Its location can be real time or schedule tracked by backend server or specified terminals.
Function Key Geo-Fence mode Long press the key to enable/disable Geo-Fence ID0 Geo-Fence in current position mode Long press the key to enable/disable Geo-Fence ID0. If enable Geo-Fence ID0, using the current position as the centre of Geo-Fence 0. SOS mode (default) Long press the key to active SOS alarm Mini USB interface Connect a 5V DC adapter can power on Prime At Lite and charge the internal battery Connect a 3.
Power key was pressed and prepare to power off Fast flash (red) Power key was pressed and prepare to power on Fast flash (green) 2.4 External Power Interface 2.4.1 External DC Charger Interface The Pin2 on Mini-USB connector is used for charging and named as VCHG pin, which can be connected to 5V DC power source to power on Prime At Lite device and charge the current battery. Figure 1-3 PIN NO.
2.4.2 External Battery Interface The Pin 8 and Pin9 on Mini-USB connector are used for external battery and named as EXTBAT pin, which can be connected to 3.7V Li-ion or Li-Polymer battery to power on Prime At Lite device. The Pin6 on Mini-USB connector is used for external battery interrupt detection and named as EXT_VBAT INT, which must be connected to GND for EXT_VBAT detection. Figure 1-4 PIN NO.
3 Getting Started 3.1 Parts List Name Picture Remark Prime At Lite Locater The GSM/GPRS/GPS locator. AC-DC Power Adapter It is used to charge the internal battery of Prime At Lite. Prime At Lite Data and charger Cable It the USB data cable which can be used for firmware upgrading and configuration. It also includes the charger interface on the Prime At Lite. 3.2 Battery Charging The following items are suggestion for battery charge, please pay more attention.
3.3 Prime At Lite Data Cable Prime At Lite Data Cable is a cable with a Mini USB connector. The USB data cable is used for data download, which will be used for firmware update or configuration and can be used for charging at the same time. Figure 2-1 3.4 How to insert SIM Card Figure 2-2 Step1: pull out the cover of SIM card..
shown. Step3: push the cover back. 3.5 Power on/Power off Figure 2-3 Power on: Press the Power key at least 3 seconds and release it to power on Prime At Lite device. Note that, the Power LED light will fast flash. Power off: Press the power key about 3 seconds; Power LED light will fast flash and then turn off, which indicates that Prime At Lite device has been powered off. Note: the user can not power off Prime At Lite if the power key is disabled by protocol.
4 Trouble shooting and Safety info 4.1 Trouble shooting Trouble Messages can’t be reported to the backend server by GPRS. Possible Reason Solution The SIM card in Prime At Lite doesn’t support GPRS. Try a GPRS supported SIM card. APN is wrong. Some APN can not visit the internet directly. Ask the network operator for the right APN. The IP address or port of the backend server is wrong. Make sure the IP address for the backend server is an identified address in the internet.
FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types AT Lite (FCC ID: Z24-ATL) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification when properly worn on the body is 0.770W/kg. This device was tested for typical body-worn operations with the back of the handset kept 1.5cm from the body.
