Prime 911A4G User Manual Revision: 1.00 Document Title Version 1.
Contents 1 Introduction .................................................................................................................................... 3 2 Product Overview .......................................................................................................................... 3 2.1 Appearance .......................................................................................................................... 3 2.2 Buttons Description..............................................
1 Introduction Prime 911A4G is a rescue device with voice function.It works on LTE B2 / B4 / B12 network with superior receiving sensitivity. Based on the embedded wireless tracking protocol, Prime 911A4G can communicate with the backend server through LTE network, and transfer emergency reports. 2 Product Overview 2.1 Appearance Figure 1-1 2.2 Buttons Description Button /12PIN Interface Description KEY/interface Description Energy query Key Query How much energy left.
2.3 LED Description To be added Figure 1-2 There are 2LED lights in Prime 911A4G device, the description as following. Light Event State Red LED Blue LED Power on Steady light charging Slow flash Power on Steady light Network indicate Slow flash 3 Getting Started 3.
charging Dock charging for the device 3.2 Battery Charging The following items are suggestion for battery charge, please pay more attention. The red LED of charging Dock will be steady light no matter rescue device is charging or not. Charging will last about 3 hours. Note: If the Rescue device is firstly used, please make sure the battery is fully charged, which will make the life of battery much longer. 3.3 Charging Dock Charging Dock is a base with an AC Adapter.
3.4 Power on/Power off Figure 2-2 Power on: Press the SOS key at least 3 seconds and release it to power on rescue device. Power off: Rescue device is auto power off and user can’t turn off the machine by itself. 4 Frequency LTE:Band2、Band4、Band12 WIFI:2.4GHz 4.1 WIFI The device role of WIFI could be Master and Slave.
5 Trouble shooting and Safety info 5.1 Trouble shooting Trouble Possible Reason Solution Messages can’t be reported to the backend server by Mobile network. APN is wrong. Some APN can not visit the internet directly. Ask the network operator for the right APN. The IP address or port of the backend server is wrong. Make sure the IP address for the backend server is an identified address in the internet. Unable to power off ATW. The function of power key was disabled by AT+GTFKS.
FCC Caution. FCC Statement Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.