MDD23W Series MDD58W Series Pro-Line Wine Dual-Temperature Wine Keg Storage & Dispensing PLEASE READ BEFORE USE Before getting started please read this user manual and at all times follow the important safety instructions.
Pro-Line Wine Wine On Tap Keg wine is the smart choice. Fine varietal wines are now in kegs. Serve wine at the optimal temperature the vintner intended it to be enjoyed. Pro-Line Wine units feature dedicated dual-temperature zones: one for whites (45°F) and one for reds (55°F). Keg wine is a great value with minimal waste and stays fresh until poured.
Pro-Line Wine Table Of Contents Receiving & Inspecting .........................................................................Page 3 Location ......................................................................................................Page 4 Installation .................................................................................................Page 4 • Install Wine Font • Install Keg Tapping Kit Specifications & Dimensions ..............................................................
Pro-Line Wine Receiving & Inspecting Upon receiving your new Micro Matic Pro-Line Wine dispenser, check the package and the unit for any damages that may have occurred during transportation. Visually inspect the exterior of the package. If damaged, open and inspect the contents with the carrier. Any damage should be noted and reported on the delivering carrier’s receipt.
Pro-Line Wine Location • Be sure the location chosen has a floor strong enough to support the total weight of the unit and contents. • Recommended to use a professional installation company. • For the most efficient operation, be sure to provide good air circulation around the unit. • MDD23W cannot be used for built-in applications. • Avoid hot corners and locations near stoves and ovens. • It is recommended the unit be installed no closer than 2" from any wall.
Pro-Line Wine Specifications & Dimensions MDD58W Series Capacity of 20 Liter Kegs 8 (4 per zone) Running Amps 6.5 Cubic Feet Per Side TBD Condenser HP 1/3 Hole for Wine Font 2 Voltage 115/60/1 Hole Diameter 3" Color-coded Digital Thermostats 2 (Blue LED-Whites & Red LED-Reds) Plug Type NEMA-5-15P Temperature Range–Whites 42–48°F (5.5–8.8C) Cord Length 8' Temperature Range–Reds 55–65°F (12.7–18.3C) Refrigerant R-134a Approval ETL Listed Charge oz (Grs) 10.
Pro-Line Wine Specifications & Dimensions MDD23W Series Capacity of 20 Liter Kegs 4 (2 per zone) Running Amps 2.7 Cubic Feet Per Side TBD Condenser HP 1/6 Hole for Wine Font 1 Voltage 115/60/1 Hole Diameter 3" Color-coded Digital Thermostats 2 (Blue LED-Whites & Red LED-Reds) Plug Type NEMA-5-15R Temperature Range–Whites 42–48°F (5.5–8.8C) Cord Length 8' Temperature Range–Reds 55–65°F (12.7–18.3C) Refrigerant R-134a Approval ETL Listed Charge oz (Grs) 10.
Pro-Line Wine Keg Temperature: Storage & Serving Storage It is important to understand that when the keg of wine is delivered it must be properly stored. • White wine must be stored inside the cooler as soon as possible, as it may take as many as 24 hours for the temperature to be reduced to the desirable range. • It is recommended to store both reds and whites at room temperature (approximately 72°F.
Pro-Line Wine MDD23W Air & Wine Temperatures This chart shows that air temperature cycles, but keg (liquid) temperature remains consistent. www.micromatic.
Pro-Line Wine Adjusting the Thermostat The Pro-Line Wine dispenser is designed to maintain your wine keg temperature within the most desirable range of 45° to 55°F (depending on the varietal). You can expect the Pro-Line unit to maintain temperature with the proper temperature control setting and in a normal environment. If a different setting is desired, follow these instructions to adjust the thermostat.
Pro-Line Wine How To See The Set Point 1. Push and immediately release the 2. P ush and immediately release the normal display. key, the set point will be displayed. key or wait about five (5) seconds to return to How To Change The Set Point 1. 2. 3. 4. To change the set point number, push the key for more than two (2) seconds. The number of the set point will be displayed and the “ ” or “ ” LED will blink. To change the set number push the arrow up or down keys within ten (10) seconds.
Pro-Line Wine Parameters for MDD23W Thermostat Parameter 11 Description For Blue Display For Red Display SEt Set point 40 56 Hy Differential 10 3 LS Minimum set point 40 55 US Maximum set point 46 60 ot Thermostat probe calibration 8 0 P2 Evaporator probe presence n n oE Evaporator probe calibration 0 0 od Outputs activation delay at start up 3 3 AC Anti-short cycle delay 1 1 Cy Compressor ON time with faulty probe 8 6 Cn Compressor OFF time with faulty probe
Pro-Line Wine Parameters for MDD58W Thermostat Parameter Description For Blue Display For Red Display SEt Set point 42 55 Hy Differential 10 5 LS Minimum set point 40 55 US Maximum set point 48 60 ot Thermostat probe calibration 8 5 P2 Evaporator probe presence n n oE Evaporator probe calibration 0 0 od Outputs activation delay at start up 3 3 AC Anti-short cycle delay 1 1 Cy Compressor ON time with faulty probe 6 6 Cn Compressor OFF time with faulty probe 12
Pro-Line Wine Data Plate The data plate is located inside the unit, near the top front left corner. Under no circumstances should the data plate be removed from the unit. The data plate is essential to identify the particular features of the unit and is of great benefit to installers, operators and maintenance personnel. It is recommended that, in the event the data plate is removed, you copy down the essential information in this manual for reference before installation.
Pro-Line Wine Troubleshooting Sometimes, working failures are due to simple causes which can be solved by the user. Before asking for the help of a qualified technician, you have to do some verifications. These failures are not covered by the warranty: 1. Refrigeration is not cooling? a. Check the unit is still connected to power supply. 2. T he thermostats on the Pro-Line Wine units have been factory preset at approximately 45°F for white wine dispensing and 55°F for red wine dispensing.
Pro-Line Wine Maintenance Cleaning the Cabinet • Proper cleaning of stainless steel requires a soft cloth, never use steel pads, wire brushes or scrapers. • Cleaning solutions need to be alkaline or non-chloride cleaners. Any cleaner containing chlorides will damage the protective film of the stainless steel. Chlorides are also commonly found in hard water, salts, household and industrial cleaners. • Routine cleaning of stainless steel can be done with soap and water.
Pro-Line Wine Cleaning Condenser Coil • Clean the condenser coil every three months. A dirty condenser will reduce the performance of the cooling system. • Do not block airflow to the perforated panel and do not operate the Pro-Line Wine unit in environments above 100˚F. DANGER: Power must be turned off and disconnected from the power source whenever performing maintenance, repair, or cleaning the condensing unit. • Disconnect unit from power supply.
Pro-Line Wine Wiring Diagram – MDD23W Series Standard Color Green Dark Blue Brown Light Blue Brown Dark Blue Yellow Red Black White White Black Black Striped 17 www.micromatic.
Pro-Line Wine Wiring Diagram – MDD58W Series Standard Color Green Dark Blue Brown Light Blue Brown Dark Blue Yellow Red Black White White Black Black Striped Black www.micromatic.
Pro-Line Wine Parts Listing Item Part # Description MDD23W MDD58W Castors & Legs 1 603313M0013 Castor w/o B D.3” 2 603313M0014 Castor with B D.3” 2 Compressors 2 3 4 602121M0073 Compressor EM55HNX 1 602101M0082 Start Kit Compressor EM55HNX 1 604701M0002 Filter 25gr. 1 602101M0020 Compressor NE6187Z 1 602101M0035 Start Kit Compressor NE6187Z 1 604701M0001 Filter 40gr.
Pro-Line Wine 15 Parts Listing Item Part # Description MDD23W MDD58W 16 Controllers 16 602135M032 Thermometer Digital 1 1 602135M0033 Thermometer Digital 1 1 602125M0034 Inner Side Panel Heater 1 602135M026 Probe 2 16 21 22 2 Panels 18 19 20 21 22 M10917M0549 Bottom Panel 1 M10917M0621 Inner Side Panel M10917M0567 Side Panel 1 M10917M0133 Back Panel 1 M10917M0164 Back Panel 1 M10913M0500 Top Panel 1 603305M0022 Handrail 2 603305M0005 Separator Handrail 4 8 16
Pro-Line Wine Notes: 21 www.micromatic.
Pro-Line Wine Warranty For warranty service call: 1-800-544-0400. Please have the model number and serial number. Warranty Claims Procedure: If there is a defect in material or factory workmanship covered by this Warranty reported to Micro Matic during the period the applicable Warranty is in force and effect, Micro Matic will repair or replace, at Micro Matic’s option, that part of the Equipment that has become defective.
www.micromatic.com • 1 (866) 327-4159 01270-D1212 ©2012 Micro Matic USA, Inc.
