User Manual

ManualsBrandsMicroelectronics Technology ManualsElectronicsMTI RFID RF Module

Table Of Contents

MTI RFID RU-859 Module

Quick Guide

A01 AS ISSUED Eric Hsiang

LTR. E.C.O. NO. DATE CHANGE INFORMATION AUTHOR

REVISED HISTORY

DWG NO. APPROVED BY

PAGE NO. 1 OF 16

台揚科技股份有限公司

MICROELECTRONICS TECHNOLOGY INC.

ISO 9001 Certified

OTE: APPROVALS ON THIS PAGE SIGNIFY APPROVAL OF ENTIRE PROCEDURE.

Tony Kao

台揚集團智慧財產

任何未經授權逕予複製、重製、公開或使用本文之行為，將被視為侵害

台揚集團之智慧財產權，將可因此負擔法律責任。

MTI Group Proprietary Information

Any unauthorized use, duplication, reproduction, or disclosure of this document may be

considered as infringement of MTI Group’s intellectual property rights, the infringer may

be accused and liable applicable legal penalties.

Summary of content (16 pages)

PAGE 1
台揚科技股份有限公司 ISO 9001 Certified MICROELECTRONICS TECHNOLOGY INC. NOTE: APPROVALS ON THIS PAGE SIGNIFY APPROVAL OF ENTIRE PROCEDURE. MTI RFID RU-859 Module Quick Guide A01 LTR. AS ISSUED E.C.O. NO. DATE Eric Hsiang CHANGE INFORMATION REVISED DWG NO. AUTHOR HISTORY APPROVED BY Tony Kao PAGE NO.
PAGE 2
MTI RFID RU-859 Module Quick Guide PAGE: 2 台揚科技股份有限公司 ISO 9001 Certified DATE: Feb. 14 2008 MICROELECTRONICS TECHNOLOGY INC. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 3
台揚科技股份有限公司 ISO 9001 Certified MTI RFID RU-859 Module Quick Guide PAGE: 3 DATE: Feb. 14 2008 MICROELECTRONICS TECHNOLOGY INC. Table of Content Chapter 1 Introduction........................................................................................................................... 5 1.1 Purpose.................................................................................................................................. 5 1.2 Trademarks........................................................
PAGE 4
台揚科技股份有限公司 ISO 9001 Certified MTI RFID RU-859 Module Quick Guide PAGE: 4 DATE: Feb. 14 2008 MICROELECTRONICS TECHNOLOGY INC. Table of Figures Figure 1 Channel and Frequency Table ................................................................................. 6 Figure 2 Interfaces ................................................................................................................. 7 Figure 3 Pin Assignment.......................................................................................
PAGE 5
台揚科技股份有限公司 ISO 9001 Certified MTI RFID RU-859 Module Quick Guide PAGE: 5 DATE: Feb. 14 2008 MICROELECTRONICS TECHNOLOGY INC. Chapter 1 Introduction 1.1 Purpose This document provides information and procedures on installation, setup, and use of MTI RFID RU-859 Module. 1.2 Trademarks The product described in this book is a licensed product of Microelectronics Technology Inc.
PAGE 6
MTI RFID RU-859 Module Quick Guide PAGE: 6 台揚科技股份有限公司 ISO 9001 Certified DATE: Feb. 14 2008 MICROELECTRONICS TECHNOLOGY INC. Chapter 2 Product Introduction 2.1 Product and Accessories MTI RFID RU-859 Module Developer Kit (Model Number: TF-RU-859-01, optional) DC 5V 1.5A Power Supply / Power Adapter (optional) Antenna and cable (optional) 2.2 Power Supply Required DC 5V 1.5A. 2.
PAGE 7
MTI RFID RU-859 Module Quick Guide PAGE: 7 台揚科技股份有限公司 ISO 9001 Certified DATE: Feb. 14 2008 MICROELECTRONICS TECHNOLOGY INC. 2.4 Interfaces Antenna Port 1 Antenna Port 2 Control Port Figure 2 Interfaces Antenna Ports z Standard Female MMCX Connector. Control Port z 2x15pins 1.
PAGE 8
MTI RFID RU-859 Module Quick Guide PAGE: 8 台揚科技股份有限公司 ISO 9001 Certified z DATE: Feb. 14 2008 MICROELECTRONICS TECHNOLOGY INC.
PAGE 9
MTI RFID RU-859 Module Quick Guide PAGE: 9 台揚科技股份有限公司 z DATE: Feb. 14 2008 MICROELECTRONICS TECHNOLOGY INC.
PAGE 10
台揚科技股份有限公司 ISO 9001 Certified MTI RFID RU-859 Module Quick Guide PAGE: 10 DATE: Feb. 14 2008 MICROELECTRONICS TECHNOLOGY INC. Chapter 3 Installation Before starting installation, please uninstall any prior version of Intel RFID Tracer from your system. 3.1 Install Procedure Step 1: Open folder “Software\Tracer (GUI)\current release\”. Step 2: Run the file Setup.exe. Step 3: The setup program will check for and optional install the C++ runtime libraries and the .Net 2.0 Framework.
PAGE 11
MTI RFID RU-859 Module Quick Guide PAGE: 11 台揚科技股份有限公司 ISO 9001 Certified DATE: Feb. 14 2008 MICROELECTRONICS TECHNOLOGY INC. Chapter 4 Reading Tags The following procedure explains how to install and operate RU-859 Module with RFID Tracer on your PC. 4.1 Setup Connect RU-859 module to accessories, as shown in Figure 5. Serial Port USB Port DC 5V 1.
PAGE 12
MTI RFID RU-859 Module Quick Guide PAGE: 12 台揚科技股份有限公司 ISO 9001 Certified DATE: Feb. 14 2008 MICROELECTRONICS TECHNOLOGY INC. 4.2 Open RFID Tracer Step 1: Start RFID Tracer by double clicking on the RFID Tracer.exe. icon Step 2: When start RFID Tracer with RU-859 module at first time, you might need to install USB2.0 driver for communication. You could find the USB driver zipped at folder “Software\Drivers and SDK\Linux\”, or “Software\Drivers and SDK\Windows\”, depend on your operation system. 4.
PAGE 13
MTI RFID RU-859 Module Quick Guide PAGE: 13 台揚科技股份有限公司 ISO 9001 Certified Step 2: Select “Antenna Ports” listed on the left-hand side selection bar, as shown in Figure 7. Figure 7 Step 3: DATE: Feb. 14 2008 MICROELECTRONICS TECHNOLOGY INC. Reader Configuration Panel The Antenna Ports page is used to configure the reader’s sixteen logical antenna ports. As Figure 8 shows, the screen has a grid which displays the current antenna configuration.
PAGE 14
MTI RFID RU-859 Module Quick Guide PAGE: 14 台揚科技股份有限公司 ISO 9001 Certified Step 4: DATE: Feb. 14 2008 MICROELECTRONICS TECHNOLOGY INC. To change the setting for a logical antenna, click on the edit button in the first column of the grid. This will bring up the dialog box shown in Figure 9. Figure 9 Step 5: Antenna Logical Settings If using antenna port 1, then configure Tx Physical Port indicating the physical connector with 1 or 3.
PAGE 15
MTI RFID RU-859 Module Quick Guide PAGE: 15 台揚科技股份有限公司 ISO 9001 Certified DATE: Feb. 14 2008 MICROELECTRONICS TECHNOLOGY INC. 4.4 To Read Tags Step 1: Click “Run Inventory” at Control Panel, as shown in Figure 10. Figure 10 Main Window and Control Panel Step 2: Select views that allow users examine RFID data from a number of different perspectives, as shown in Figure 11. Views are selected from the View menu of the main window.
PAGE 16
MTI RFID RU-859 Module Quick Guide PAGE: 16 台揚科技股份有限公司 ISO 9001 Certified DATE: Feb. 14 2008 MICROELECTRONICS TECHNOLOGY INC. View Name Contents Summary View Overview statistics about the current session, currently executing command and reporting time slice. Standard View A list of unique tag singulations (tag id inventoried) in the session and a count of the number of times the id was read (inventoried).