Micro Device S.r.l. User’s manual Dual Band model Version 1.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 E-mail mdevice@tin.it This document contains proprietary intellectual information exclusively owned by Micro Device S.r.l. Italy. All information contained herein is the exclusive property of Micro Device. It cannot be disclosed to anyone without the written permission of the owner.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it Summary SUMMARY .........................................................................................................................................................3 1. INTRODUCTION ............................................................................................................................................4 1.1. GENERAL FEATURES OF THE TRANSMITTER ...........
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it 1. Introduction Yacht Controller Dual Band, developed by Micro Device S.r.l., is an electronic wireless remote control, able to control a boat in the basic manuvering and mooring functions.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it 1.1. General features of the transmitter On the transmitter, there are always two levers to control the engines forward and reverse, two levers to control the bow and the stern thrusters right and left, two buttons to control the anchor winch up and down the button to engage the command and the button of switching on/off.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it 1.2. General features of the Receiver The receiver is housed in a polycarbonate box, placed inside and out of view of the chosen helm station. The receiver is turned on by a separate switch installed by the technician normally nearby the helm station. The receiver acquires the commands of the transmitter and activates the functions of the boat accordingly.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it 2. Yacht Controller Dual Band operation The commands on the receiver are activated by the respective switches placed on the transmitter. The transmitter cyclically transfers the state of the switches and of the buttons to the receiver. The command will remain active as long as the corresponding switch is pressed.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it • Never use the transmitter if you are not on board the boat which you are commanding. Remember that the abandon of a vessel in Italy and in other Countries is illegal and it is a punishable crime. • In the event the LED signals low battery replace both batteries within short time.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it 2.2. Activation procedure In order to activate Yacht Controller, follow step by step the procedure described in this paragraph. • Start the main engines in accordance with the usual procedure. • Enable the boat helm station to which the Yacht Controller Dual Band receiver is connected to.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it • Every activation of the outputs is signalled by the lighting of the correspondent green leds associated to each of the command modules on the receiver. WARNING: From now on, the system is operating. You must pay the maximum attention, because the involuntary pressure on any of the lever or button switches, will cause the activation of the related command output.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it 2.3. Deactivation procedure To deactivate Yacht Controller Dual Band, follow the procedure described in this paragraph: • Turn the transmitter OFF by pressing the proper button until all leds switch ON (security time longer than 3 seconds to avoid accidental misuse).
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it 3. How to use Yacht Controller Dual Band The Yacht Controller Dual Band allows you to operate certain functions of the boat in a simple and safe way. By pressing the related switches of the transmitter, it is possible to action, from any point of the boat, engines, bow or stern thrusters, anchor winch.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it 3.2. Anchoring and hooking to mooring buoys 3.2.1 Dropping the anchor Once you have selected the optimal position for the anchorage, put the control levers in neutral position, and properly activate the Yacht Controller Dual Band as previously described in the paragraph 2.2..
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it 3.3. Other situations In addition to what has been already described, the Yacht Controller Dual Band will be useful in many other situations: • During tieing up to a dock for fuel or supplies, especially in confined places you will be able to easily control the boat from greater visibility points without risking collisions and screaming at your mates.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it 4. Maintenance 4.1. Replacement of batteries When the battery discharge LED flashes, it is necessary to replace within two/three hours of operation both batteries of the transmitter. It’s a good rule to keep always on board three first quality alkaline batteries of 1,5V type AAA (LR06). DANGER: Before working on the transmitter, make sure that the receiver is OFF.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it Check if the waterproof gasket is ok. Replace it if damaged to avoid that the electronics of the transmitter has damages in case of washing or fall in water. Once finished screw the cover again. WARNING: • This device contains batteries. Attention: exhausted batteries must be discarded in accordance with local and federal regulations.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it 4.2. How to clean the transmitter After using your Yacht Controller Dual Band, remove any salt residue by wiping with a soft cloth using fresh water. ALWAYS avoid soaking it. In case the transmitter has fallen into salt water, immediately turn OFF the receiver following the procedure described in this manual.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it 4.3. Problems and malfunctions This paragraph describes a series of problems and malfunctions which could happen in using the Yacht Controller Dual Band system, the possible cause, and possible solutions to the problem. For further assistance please contact your installer or Micro Device. Problem Possible cause The receiver does not turn ON.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it Problem The acoustic signal of the receiver emits intermittent signals. Possible cause The wireless transmission is interfered by radio-frequency sources nearby The distance between the receiver and the transmitter has exceeded the signal range. Remedy - remove, if possible, the source of disturbance.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it 5. Technical specifications Power: 3 alkaline 1,5 batteries AAA (LR03) type Cover: In ABS with protection degree IP68. Number of channels: 10 Transmission code: 16 bit digital Dimensions (LxAxP) 70 x 123 x 43 mm Weight: with batteries in, 145 g Power of transmission: 10mW (30-50 mt. max) Frequencies: 433.92 and 868.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it 6. Warranty Each Yacht Controller Dual Band system is warranted for 24 months, as from the date of sale to the first user . The warranty on the Micro Device S.r.l.’s devices is for all the possible defects of material and breakdowns not caused by the customer. Regarding the installation and the possible maintenance operations, these are responsibility of the installer.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it 7. FCC - CE Mark 0051 YACHT CONTROLLER DUAL BAND IS A SYSTEM IN COMPLIANCE WITH THE FOLLOWING CE DIRECTIVES: DIRECTIVE R&TTE • EN 300 220-1 V2.1.1 • EN 301 489-1 (V1.8.1) + EN 301 489-3 (V1.4.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it FCC ID: R86TX001YCDB YACHT CONTROLLER DUAL BAND IS A SYSTEM IN COMPLIANCE WITH THE FCC DIRECTIVE. Position of the FCC mark on the receiver (above) and on the transmitter (right) Verification according to § 15.19 (a) (3): This device complies with Part 15 of the Rules.
Micro Device srl Via Bellini, 31/33 20095 Cusano Milanino (MI) Tel. +39.02.6131001 r.a. Fax. +39.02.66400086 Email mdevice@tin.it YACHT CONTROLLER DUAL AND IS A SYSTEM IN COMPLIANCE WITH CE DIRECTIVES FOR TRANSMITTERS IN NAUTICAL ENVIRONMENTS AND THE DIRICTIVES FOR ELECTOMAGNETIC COMPATIBILITY AND IMMUNITY TO ELECTOMAGNETIC DISCHARGES Conformity Declaration The manufacturer: Micro Device S.r.l.