Micro Device S.r.l. Installator’s guide. Preliminary Version Reviewed on 21.05.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it This document contains reserved and confidential information owned by Micro Device S.r.l. Its contents can never be revealed in any way without a written permission of the owner. ATTENTION: BEFORE INSTALLING YACHT CONTROLLER SYSTEM READ CAREFULLY THE PRESENT MANUAL AND PROCEED TO THE INSTALLATION FOLLOWING PUNCTUALLY THE INSTRUCTIONS.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it Summary SUMMARY .........................................................................................................................................................3 1. INTRODUCTION ............................................................................................................................................4 1.1. COMPOSITION OF THE KIT ...............
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it 1. Introduction Yacht Controller, developed by Micro Device S.r.l., is an electronic remote control wireless, able to control a boat in his essential parts. From the first prototype, going back to 1998, “Yacht Controller” has undergone a continuous evolution.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it 1.1. Composition of the kit The kit of installation of Yacht Controller system includes: 1. 2. 3. 4. 5. 6. 7. A receiver, held in a grey polycarbonate container with a transparent cover. A transmitter, very similar to a remote control. A connector, to connect to the receiver, complete of cables of the length of 1,5 meters. A kit of connectors for quick installations.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it Electronics is held in a grey ABS container which combines functionality with an IP65 protection degree (resisting to the water sprinklings but not dipable). The container is composed of two parts gathered between them without screws through two covers. Removing the lower cover it is possible to enter into the box containing the batteries.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it 1.3. General receiver features The receiving unity acquires the transmission of the radio control and commands the relays connected to the operations of the boat. The command of the relays takes place with the activation of the respective switches on the transmitter.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it 2. Installation and connection 2.1. Installation environment The receiver MUST be installed far from devices (i.e. electric engines or electric lines of power) which can produce an electromagnetic field that can disturb the radio signal issued by the transmitter.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it During the installation, the FORM supplied with the manual, will have to be filled in every part. In case of need, this will allow the Customer Service, to determine the contromisure to be undertaken to solve eventual problems.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it 2.2.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it 2.2.2 Connection of the feeding wires Determine the command station interested in the installation and the space suitable to contain the receiver. . WARNING: Before connecting or disconnecting the electric cables of the receiver, check that the feeding is not present and that the command station interested to the connections is not active.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it 2.2.3 Connection of the engine wires For installing the engine command exits it is necessary to identify the cables that from the control levers go to the electronic switchboard and to connect in parallel to them the cables coming out from the receiver (see figure 4). In order to make the wiring easier, Micro Device S.r.l.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it Figure 8: Connection of the bow thruster WARNING: Do not connect the command exits of the receiver directly to the engines of the propeller, but always connect them to the command joystick. 2.2.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it Figure 10: Connection scheme of the anchor winch. WARNING: Do not connect the command exits of the receiver directly to the anchor winch, but always connect them to the command switch. 2.2.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it Figure 12: Connection scheme of the external acoustic signal with relay.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it 3. Functionality test IMPORTANT: If installed correctly, Yacht controller, does not need calibrations. Once connected and checked the wires, it is possible to proceed with the functionality test.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it It is anyway possible to test the correct operativity of the commands of the engines, following step by step the following instructions: • Ignite the engines following your usual procedure. • Enable the station of command of the boat which the unity of receiving of Yacht Controller is connected to.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it 3.1. Programming instructions The receiver in the kit is already arranged to receive the commands from the associated transmitter. WARNING: The programming procedure described here must be used only to qualify the receiver for receiving commands from a further transmitter or in case of replacement of the original transmitter.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it 3.1.2 Cancellation of the receiver memory Sometimes deleting the memory of the receiver is needed. As an example, in the case in which the transmitter has been broken or lost, or if the memory of the receiver is saturates and you want to change the list of the transmitters. The procedure to delete the memory of the receiver is the following: 1.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it 4. Functionality problems This section describes a series of problems and malfunctions which could happen during the installation, with the possible cause and, where possible, the contromisure to solve the problem. If solving the problem by yourself is impossible, please ask Micro Device’s Customer Service. Problem Possible causes The receiver is not ignited.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it Problem Possible causes Remedy The commands of the right/left engines are reversed. Wrong identification of the wires of the two engines. On the connector of the command exits, reverse the wires 3, 4, 5 with the wires 6, 7, 8. The commands ahead/back of the right engine are reversed. Wrong link of the wires of the On the connector of the engine.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it 5. Technical specifications 5.1. Transmitter Feeding: 2 alkaline 1,5 batteries AAA (LR03) type Absorption: 30mA in transmission Cover: In ABS with protection degree IP65. Number of channels: 4, 6, or 8 according to the models.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it 6. Warranty Each Yacht Controller system is guaranteed for 24 months, as from the date of sale to the first user. The warranty on the Micro Device S.r.l equipment is effective for all the possible faults of manufacture, material and for all the breakdowns not imputable to the customer.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it Test and recording form Send by fax to Micro Device S.r.l., +39-02-66400086, to activate the warranty. Customer : Telephone: Boat: Name: Type of the electronics control: Engines: Receiver matriculation number: .
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it 7.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it Conformity Declaration The Constructor: Micro Device S.r.l. Via Bellini, 31/33 20095 Cusano Milanino (MI) declares that the product: Yacht Controller is in compliance with the qualifications and with the pertinent dispositions established from the Directive 1999/5/CE.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.it Appendix The receiver is supplied with an exit connector assembled with cables of the length of about a meter. The colours have been chosen to make easier the connection with several electronic switchboards. Below is provided a table of the correspondences between the colour of the cables and the activation exits for the managed electronic switchboards.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.
Micro Device s.r.l Via Bellini, 31/33 20095 Cusano Milanino (MI) Italy Tel. +39 02 6131001 r.a. Fax. +39 02 66400086 E-mail mdevice@tin.