User's Manual

MEMS
Command Unit
The final user manual will contain the following
text:
PRODUCT CERTIFICATION
Model: RV3
-
01
-
CF
FCC ID: FI5
-
RV3
-
01
-
CF
IC: 5056A
-
RV301CF
This device complies w
ith part 15 of the FCC Rules
. Operation
is
subject to the following
two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Any modification or changes made to this
device, unless explicitly approved by Michelin, will invalidate the
authorisation of this device. Operation of an unauthorised device is prohibited under Section 302 of the
Communications Act of 1934, as amended, and Subpart I of Part 2 of Chapter 47 of t
he Code of Federal
Regulations
.
This equipment must only be
used with the antenna supplied. F
ailure to do this may void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the u
ser will be required to correct the interference at his own expense.
This device complies w
ith Industry Canada license
-
exempt RSS standard(s)
. Operation is
subject to the
following
two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may cause undesired operation.
This radio transmitter
has been approved by Industry Canada to operate with the antenna types listed
below with
the maximum permissible gain
and required antenna impedance for each antenna
type indicated. Antenna types
not included in this list, having a gain greater than the maximum
gain indica
ted for that type, are strictly
prohibited for use with this device.
Procom FSP 70/433MHz
+5dB gain
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appa
reil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Le présent émetteur radio
a été approuvé par Industrie Canada pour
fonctionner avec les types d'antenne
énumérés ci
-
dessou
s et ayant un gain admissible maximal et
l'impédance requise pour chaque type d'antenne.
Les types d'antenne non inclus dans cette liste,
ou dont le gain est sup
érieur au gain maximal indiqué,
sont
strictement interdits pour
l'exploitation de l'émetteur.
P
rocom FSP 70/433MHz
+5dB gain
Category II licence
-
exempt radio apparatus
Carrier frequency 125kHz; RF field strength 54.3dBµV/m @ 3m.
La fr
é
quence porteuse 125kHz;
L
’
intensit
é
de champ 54.3dBuV @ 3m.