User's Manual

MEMS Receiver Installation

Page1

MEMS Receiver Installation

These instructions relate to the installation of the Michelin Earthmover Management System (MEMS)

Receiver identified by the part numbers RV2–01 and RV2–01-FCC.

WHAT YOU WILL NEED

Supplied by Michelin:

• MEMS Receiver

• Power cable

• Antenna with 10M cable

• Antenna with 5M cable (Driver’s side) Identified with red ring on antenna

• Thermal cut-out

• Panduit flexible conduit (15M supplied)

Supplied by the MEMS real time interface provider:

• Interface cable for mine management system

Local supply

• Vehicle wiring connectors conforming to local regulations. Cable clips

• Suitable self tapping or other screws to secure the MEMS Receiver to the vehicle

Tools

• Wireman’s / Electricians tools

• Electric drill

IMPORTANT

NOTE: This system must be installed by experienced professional installers who are familiar

with radio frequency (RF) equipment operation as well as local building and safety codes.

Failure to do so may void the Product Warranty, as well as expose the end user to legal and/or

financial liabilities. The device and its antenna must not be co-located or operating in

conjunction with any other antenna or transmitter.

Any changes or modifications of equipment not expressly approved by the manufacturer could

void the user's authority to operate the equipment and the company's warranty.

PAGE 1
MEMS Receiver Installation MEMS Receiver Installation These instructions relate to the installation of the Michelin Earthmover Management System (MEMS) Receiver identified by the part numbers RV2–01 and RV2–01-FCC. IMPORTANT NOTE: This system must be installed by experienced professional installers who are familiar with radio frequency (RF) equipment operation as well as local building and safety codes.
PAGE 2
MEMS Receiver Installation RECEIVER INSTALLATION • The MEMS Receiver should be mounted in an environment that is suitable for electronic equipment; inside the cab of the vehicle. • Secure the MEMS Receiver using the four mounting points that will be found at the ends of the steel brackets. • Access to the front panel is required for service and other operations. • Do NOT mount the MEMS Receiver where it is in the path of air from cab heaters.
PAGE 3
MEMS Receiver Installation 2.’ Power’ Connections Connect the vehicle power to the receiver using the supplied cable which should be plugged into the left hand connection on the MEMS Receiver which is labelled POWER The MEMS Receiver power supply should be controlled by the vehicle’s ignition switch and MUST be protected by the thermal cut out that is provided. The standard of wiring must be no less than that adopted by the truck manufacturer and must conform to relevant national standards.