User's Manual

ManualsBrandsMIAONOVA ManualsCamera & PhotoSmart Security Light Camera

Table Of Contents

Key Features

Smart Security Light Camera

User Manual

Installation Steps

2.Download and install

“TuYa Smart” app

>Open app

>Registered account

1.Fix the Wall Mouting Plate

> Connect the power cable

>Mount the Camera housing

> Power it up

3. Click Add Device > select Security &

Sensors > Smart Camera

> click Other Mode(upper right)

> select Mode

> click next step

Spare Parts List

Cover Pad

(Option)

PIR

Main Light

Top Light

Wall Mouting Plate

Speaker

Reset Button

MIC

Micro SD

Bottom Lock Screw Hole

Indicator

Top Lock Screw

Power wire via Hole

Camera Lens

●1080P Full HD Security Camera

●1200 Lumen White LED Lamp

● APP View Live Video & Playback

●PIR & Sensor Dual Detection

●Two Way Audio

●APP Push Notifications

●APP Control Light & Adjust Brightness

●Waterproof

X1 X1

Bracket

(Option)

★NOTE: This product only supports QR code & Smart Mode & Wired

Network(Option,Only for Ethernet Version)

★ Product as AP mode are not supported; Please refer to the following APP

Installation And Initial Configuation

Maimiao MX5

Summary of content (5 pages)

PAGE 1
Smart Security Light Camera Maimiao TM Installation Steps Top Light MX5 Top Lock Screw User Manual Wall Mouting Plate Main Light Power wire via Hole Key Features Bottom Lock Screw Hole Speaker Camera Lens ●1080P Full HD Security Camera ●1200 Lumen White LED Lamp ● APP View Live Video & Playback PIR Reset Button MIC Indicator Spare Parts List Micro SD 1.
PAGE 2
Product Installation Instruction 1.Hold the side of Wall Mouting Plate by hand, slightly rock up and down, then pull out the Wall Mouting Plate A A D C B B C D E A LAN F G A Top Lock Screw M4 Screw A.Screw hole B.Square outlet fixing screw hole C.Rectangleoutlet fixing screw hole D.Round bracket nut fixing hole E.Green Power socket G.LAN Socket(Option) Bottom Lock Screw Hole Cover Pad 3.
PAGE 3
APP Installation And Initial Configuation 1.Preparation After power on 1 minute > check the device is waiting for installation (red Indicator light is flashing ),if not please reset the device(Press and hold the reset button for 5 seconds then release) >Cell phone connected to the same WiFi router >Check the WiFi signal strength displayed by the cell phone at the place where the device is installed is no less than 2 bars. 2.
PAGE 4
Operation Status Description Common Fault List 1.Red indicator : blinks means searching network. Blue indicator: blinks means network connection is successful. meanwhile searching the server. Always lights means device online. Yellow indicator: blinks means Ethernet active. Green indicator: blinks means Ethernet access successful. 2.
PAGE 5
NOTE This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Changes or modifications not expressly approved by the party responsible for compliancecould void the user's authority to operate the equipment.