User's Manual

Manufacturer : Xiaomi Communications Co., Ltd.
Manufacturer postal address: The Rainbow City of
China Resources, NO.68, Qinghe Middle Street,
Haidian District, Beijing, China 100085
Brand: MI Model: MDY-10-EP
FCC ID: 2AFZZ-MDY10EP
All rights reserved by Xiaomi Inc.
Efwjdf!po;!Gmbtift!uisff!ujnft
+
+
+
+
+
Tuboecz!npef;!Pgg
Usbotgfssjoh!qpxfs;!Tpmje
Qspufdujpo!npef;!Gmbtijoh
Fssps;!Gmbtijoh
Using the Wireless Charger
Note: Only approved Mi chargers that support fast charging (27W QC 3.0 chargers and
18W QC 3.0 chargers) may be used.
Connect a charger to the wireless charger, then place a mobile device which meets the QI
wireless charging standard onto the wireless charger.
After the mobile device is done charging, remove it from the wireless charger.
May only be used with approved Mi chargers (QC 2.0, QC 3.0, and PD chargers)
Never place items such as metal objects, magnets, or magnetic stripe cards between a
mobile device and the wireless charger, as this could prevent the device from charging
properly or cause damage from overheating.
Charger should be securely plugged into an electrical outlet when charging.
A mobile device may not charge properly depending on where its wireless charging coil is
located.
Wireless charging may not work properly if a mobile device is enclosed in a thick protective
case. If a mobile device has a thick protective case, remove it before placing the device onto
the wireless charger.
If a mobile device is placed onto the wireless charger while connected to earphones, it may
prevent the device from charging.
Fast wireless charging
To begin fast wireless charging, place a Mi phone which supports fast wireless charging onto
the wireless charger. For more details, please refer to the User Manual.
Nj!Xjsfmftt!Dibshfs
Rvjdl!tubsu!hvjef
RED Declaration of Conformity
We, Xiaomi Communications Co., Ltd.
EU Regulations
This Mi Wireless Charger complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including anterference that may cause
undesired operation.
This Mi Wireless Charger has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiated radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC Regulations
Frequency Bands and Power
This product is QI certified by the Wireless Power Consortium (WPC), which means it is able to
charge other WPC certified products. However, please note that variations in certain products
may cause them to have reduced charging efficiency compared to Mi brand products.
Follow relevant laws and regulations. Do not use your device in the following environments.
Do not use your device in a potentially explosive environments include fuelling areas, below
decks on boats, fuel or chemical transfer or storage facilities, areas where the air contains
chemicals or particles, such as grain, dust, or metal powders. Obey all posted signs to turn off
wireless devices such as your device or other radio equipment.
Do not use your device in the hospital operating rooms, emergency rooms, or intensive care
units.Please consult your doctor and the device manufacturer to determine if operation of your
device may interfere with the operation of your medical device.To avoid potential interference
with the pacemaker.keep a minimum separation of 15 cm be maintained between the device
and the pacemaker . To achieve this use the device on the opposite ear to your pacemaker and
do not carry it in a breast pocket.Do not use your device near hearing aids, cochlear implants,
etc to avoid interference with medical equipment.
Do not use your devices in places with high humidity such as bathrooms. Doing so may result in
electric shock, injury, fire, and charger damage.
Observe any rules which restrict using wireless charger in specific cases and environments.
Safety precautions
For indoor use only
To identify electrical equipment designed primarily for indoor use.
Direct current
To indicate on the rating plate that the equipment is suitable for direct current only;
to identify relevant terminals.
Correctly dispose of this product. This marking indicates that this product should not
be disposed with other household wastes throughout the EU. To prevent possible
harm to the environment or human health from uncontrolled waste disposal, recycle
responsibly to promote the sustainable reuse of material resources. To safely recycle your
device, please use return and collection systems or contact the retailer where the device
was originally purchased.
Hereby, Xiaomi Communications Co., Ltd. declares that this Mi Wireless Charger with
Qi MDY-10-EP is in compliance with the essential requirements and other relevant
provisions of the RE Directive 2014/53/EU.The full text of the EU declaration of conformity
could be consulted at www.mi.com/en/certification
This Mi Wireless Charger offers the following frequency bands in EU areas only and maximum
radio-frequency power：
Qi : 110~145Khz : 2.93dBuA/m at 10 m Distance
Correct disposal
Temperature: 0 °C - 35 °C
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
FCC Note
Read all the safety information below before using your device.
Use only authorized accessories which are compatible with your device.
This device’s operating temperature range is 0℃~35℃. Using this device in the environments
outside of this temperature range may damage the device.
After charging is complete, disconnect the adapter from both the device and the power outlet.
Do not charge the device longer than 12 hours.
Do not try to repair the device yourself. If any part of the device does not work properly, contact
Mi customer support or bring your device to an authorized repair center.
Connect other devices according to their instruction manuals. Do not connect incompatible
devices to this device.
For PLUGGABLE EQUIPMENT, the socket-outlet shall be installed near the equipment and shall
be easily accessible.
Important safety information
ｖ ｗ
VTC!Uzqf.D!qpsu
MFE!Joejdbups!Mjhiu
XXX-XXXX-XXXX-A
啢貏忲梽〃藥⺸槪豈蹕鄘
旿誑䯤196.V12I.1165 穼梪䯤B
窹旿抰㫼䯒謖蠙䯓䯤晹鄡擄!駱䃸慇攢!餚旝
蹕鄘僨壉暀梕䯤312:妘12桸3:暀
浧賽鄡
紙鄡
棞旿䯤
㳟趼俒裶櫎!239h!晹賂㿫
▕梪酁椨墡頯䯤
澐鑨闐熌
悈訕昷媀䯤
藥宆悈
▕梪棧獸墡頯䯤
豕頥
Qboupof!Dppm!Hsbz!9D
謾骼竑濇燍嶯鲇䎋䯤
辭姉縟旿誑䯖㛽辭姉縟樰懪㓇呯靕󴛯ゔ擄
妛棧獸
叄鉢䯤Bsjbm!!4qu