VAC N BLO CAR VAC PRO SERIES INSTRUCTION MANUAL MODEL PRO-83BA DELIBERATELY MADE BETTER IN THE U.S.
Before using, check your plug to make sure it is the proper voltage for your country.
VAC N BLO CAR VAC PRO SERIES Model PRO-83BA A. 4.0 HP, Dual Power, Twin Fan Motor (MVC-157D) B. Four 6 ft. Hoses (24 ft.) (MVC-202A) C. Crevice Tool (MVC-188) D. Air Concentrator (MVC-196AA) E. Dust Brush (MVC-206B) F. Pik-All Nozzle (MVC-185A) G. Inflator Adaptor (MVC-211D) H. 9 inch Swivel Brush (MVC-190B) I. Two 20 inch Extension Wands (MVC-172A) J. Mini Attachment Kit (MVC-212) K. Shoulder Strap (MVC-49C) L. Wall Mounting Bracket (MVC-331) M. Attachment Bag (MVC-51C) N.
***READ ALL INSTRUCTIONS BEFORE USE*** VAC N BLO CAR VAC PRO SERIES Model PRO-83BA The PRO-83BA can be mounted to a wall with the wall mount bracket (MVC-331). Ideally, the center holes should be used to mount the bracket directly into a stud with the screws shown below. Mollies can be used to secure mounting bracket to sheet rock if a wall stud is inaccessible. Level wall mount bracket in desired position and mark screw locations within screw holes.
***READ ALL INSTRUCTIONS BEFORE USE*** 1. Insert the grounded Power Supply Cord into a grounded outlet. 2. Start your Vac N Blo by pushing the Toggle Switch from right to left. 3. When using the Hose (B), connect to the suction end to vacuum, and to the exhaust end for blowing. 4. The Extension Wands (I) connect to the Hose (B) to reach those inaccessible places. Eliminate bending to reach low areas and under furniture, and stretching to reach high places. 5.
CAUTION VAC N BLO IS DESIGNED FOR DRY PICK UP ONLY. DO NOT VACUUM WATER OR MOISTURE OF ANY KIND. IF YOUR VAC N BLO HAS SUCTION BUT DOES NOT CLEAN WHEN THE HOSE IS ATTACHED, REMOVE THE HOSE FROM THE SUCTION END AND PLACE IT ON THE BLOWER END. BLOW OUT THE HOSE, IT MAY BE CLOGGED. TRIPLE FILTRATION INCLUDES A PERMANENT BAG, DISPOSABLE PAPER BAG, AND CHARCOAL FILTER.
Avant utilisation, vérifier votre fiche pour s'assurer qu'il est la tension appropriée pour votre pays. Prise UK 220-240 volts EURO prise 220-240 volts Prise AUSTRALIAN 220-240 USA bouchon 110-120 peut également être utilisé au Japon.
VAC N BLO CAR VAC PRO SERIES A. 4.0 HP, Dual Power, Double moteur de ventilateur B. Quatre Tuyaux 6 pi (24 m) C. suceur plat D. Air Concentrateur E. Brosse F. Pik-All buse G. gonfleur adaptateur H. 9 pouces pivotant Brush I. Deux rallonges de 20 pouces Kit de fixation J. Mini K. bandoulière L. support mural M. attachement sac N.
***LIRE TOUTES LES INSTRUCTIONS AVANT UTILISATION*** VAC N BLO CAR VAC PRO SERIES Modèle PRO - 83BA Le PRO-83BA peut être monté sur un mur avec le support de fixation murale (MVC-331). Idéalement, les trous centraux devraient être utilisés pour monter le support directement dans un poteau avec les vis indiquées ci-dessous. Mollies peuvent être utilisés pour fixer le support de montage pour plaque de plâtre si un montant de cloison est inaccessible.
***LIRE TOUTES LES INSTRUCTIONS AVANT UTILISATION*** 1. Insérez le cordon d'alimentation à la terre dans une prise de terre. 2 . Commencez votre Vac N Blo en appuyant sur le commutateur à bascule de droite à gauche. 3 . Lors de l'utilisation du tuyau (B), se connecter à l'extrémité d'aspiration à vide, et à l'extrémité d'échappement de soufflage. 4 . Les Baguettes de rallonge (I) se connectent au tuyau (B) pour atteindre les endroits inaccessibles.
ATTENTION VAC N BLO EST CONÇU POUR SEC PICK UP SEULEMENT. NE PAS ASPIRER EAU OU L'HUMIDITE D'AUCUNE SORTE. SI VOTRE VAC N BLO A ASPIRATION MAIS NE PAS NETTOYER LORSQUE LE TUYAU EST FIXE, RETIRER LE TUYAU DE L'ASPIRATION ET LE PLACER SUR L'EXTREMITE DE LA SOUFFLERIE. PURGER LE TUYAU, IT PEUT ETRE OBSTRUE. TRIPLE FILTRATION COMPREND UN SAC PERMANENT, JETABLE SAC DE PAPIER ET FILTRE À CHARBON.
Metropolitan Vacuum Cleaner Company, Inc. 5 Raritan Road Oakland, New Jersey 07436 WWW.METROVACWORLD.